Configuring Layer 2 Interfaces; Information About Access And Trunk Interfaces; Access And Trunk Interfaces - Cisco Nexus 1000V Configuration Manual
For vmware vsphere
Hide thumbs
Also See for Nexus 1000V:
- Troubleshooting manual (280 pages) ,
- Deployment manual (49 pages) ,
- Installing manual (27 pages)
Table of Contents
Advertisement
Configuring Layer 2 Interfaces
This chapter contains the following sections:
•
•
•
•
•
•
•
•
•
Information About Access and Trunk Interfaces
This section describes how to configure Layer 2 switching ports as access or trunk ports.
For information about configuring a Switched Port Analyzer (SPAN) destination interface, see the Cisco
Note
Nexus 1000V System Management Configuration Guide.
For information about VLANs, MAC address tables, and private VLANs, see the Cisco Nexus 1000V
Note
Layer 2 Switching Configuration Guide.
Access and Trunk Interfaces
A Layer 2 port can be configured as an access or a trunk port as follows:
Prerequisites for VLAN Trunking, page 25
Guidelines and Limitations, page 25
Default Settings, page 26
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x
4
C H A P T E R
23
Advertisement
Table of Contents
