Table of Contents
Advertisement
Introduction to Router Configuration
If you understand Cisco IOS software (the software that runs your router) and you
are experienced in configuring network devices, you can use the Cisco IOS
command-line interface (CLI) to configure your router. The purpose of this guide
is to help you use Cisco IOS software to configure your Cisco 1710 Security
router. This chapter describes what you need to know before you begin
configuring your router with Cisco IOS software.
This chapter contains the following sections:
•
•
•
•
•
•
•
•
•
Understanding these concepts saves you time when you are configuring your
router. If you have never used the Cisco IOS software or need a refresher, take a
few minutes to read this chapter before you proceed to the next chapter.
If you are already familiar with the Cisco IOS software, you can proceed to the
configuration chapter that is appropriate for your network.
78-12696-01
Configuring the Router from a PC
Understanding Command Modes
Getting Help
Enable Secret and Enable Passwords
Entering Configuration Mode
Using Commands
Saving Configuration Changes
Using Debug Commands
Where to Go Next
Cisco 1710 Security Router Software Configuration Guide
C H A P T E R
1
1-1
- Quick Links:
- Using Commands
Hide quick links:
Advertisement
Table of Contents
