Related Manuals for Bosch ATX-TRM-304T01
Summary of Contents for Bosch ATX-TRM-304T01
- Page 1 ALLPLEX track Personnel Transmitter ATX-TRM-304T01 | ATX-TRM-433T01 Installation Manual...
-
Page 3: Table Of Contents
Activating Configuration Mode Configuring the Transmitter Exiting Configuration Mode Basic Transmitter Features Transmitting a Manual Alarm Man-Down Alarm Lanyard Snatch Alarm Wearing the Transmitter Testing the Transmitter Upgrading Transmitter Firmware Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL... -
Page 4: Copyright, Safety And Warranty
All software is provided "AS IS." The sole obligation of BOSCH SECURITY SYSTEMS shall be to make available all published modifications that correct program problems are published within one (1) year from the date of shipment. -
Page 5: Important Safety Notes
This will prevent damage to the unit due to lightning and excessive power line surges. 11. Restricted Access Locations are required for the installation. Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL... -
Page 6: Safety Precautions
ALLPLEX track Personnel Transmitter Safety precautions Disposal Your Bosch product has been developed and manufactured using high- quality materials and components that can be reused. This symbol means that electronic and electrical devices that have reached the end of their working life must be disposed of separately from household waste. -
Page 7: Introduction
Security Escort system. When an alarm is initiated, a signal identifying you and your location is sent to the Security Escort Central Console. The Central Console displays your location on a map along with related information. Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL... -
Page 8: System Overview
The transmitters are available in the following models. Transmitter Model Description ATX-TRM-304T01 ALLPLEX track Personnel Transmitter 303/304/433 Mhz ATX-TRM-433T01 ALLPLEX track Personnel Transmitter 433 Mhz 2014.03 | V1.0.0 | DL Installation Manual Robert Bosch (SEA) Pte Ltd... -
Page 9: Installation And Setup
The battery’s life depends on usage and enabled features. Notice! Batteries must not be disposed of in household waste. Please take used batteries to the local collection points. See www.boschsecurity.com/standards for further information. Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL... -
Page 10: Enabling And Disabling Features
1 to the OFF position and dip switch 2 to the ON position. To change the RF to 433.42 MHz, set dip switch 1 to the ON position and dip switch 2 to the OFF position. 2014.03 | V1.0.0 | DL Installation Manual Robert Bosch (SEA) Pte Ltd... -
Page 11: Factory Reset
Refer to the following table which lists the values that are being set for the respective features following the factory reset. Feature Value Transmitter Type Security Man-Down Disabled Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL... -
Page 12: Activating Configuration Mode
Caution! The ALLPLEX track system is not a substitute for safe behavior. Do not take personal risks believing that the system will protect you. 2014.03 | V1.0.0 | DL Installation Manual Robert Bosch (SEA) Pte Ltd... -
Page 13: Basic Transmitter Features
7 seconds (configurable). To reset the transmitter after a Lanyard Snatch Alarm, reinsert the lanyard pin and perform a test as described in Testing the Transmitter, page 16. Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL... -
Page 14: Wearing The Transmitter
This transmitter includes a clip you can wear over a pocket/belt, or firmly fixed to a belt. Figure 7.1: Belt Clip Attachment Side view of clip Screw holes (mandatory) Clip Screw holes (optional) Back of transmitter 2014.03 | V1.0.0 | DL Installation Manual Robert Bosch (SEA) Pte Ltd... - Page 15 The clip is designed to be worn on a security type utility belt. If worn on a thin belt, be aware that a loose fit might cause the transmitter to send a Man-Down Alarm (if enabled) when you move too much. Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL...
-
Page 16: Testing The Transmitter
If the receiver’s LED or the strobe does not light to confirm a successful test transmission, retest the transmitter. If you still do not receive confirmation, contact the security department. 2014.03 | V1.0.0 | DL Installation Manual Robert Bosch (SEA) Pte Ltd... -
Page 17: Upgrading Transmitter Firmware
Transmitter firmware can be upgraded wirelessly via a dedicated coordinator using the Utility Tool of the Security Escort software. For more information on the usage of Utility Tool, please refer to the Security Escort Installation and Setup Manual. Robert Bosch (SEA) Pte Ltd Installation Manual 2014.03 | V1.0.0 | DL... - Page 20 Robert Bosch (SEA) Pte Ltd 11 Bishan Street 21 573943 Singapore Singapore www.boschsecurity.com © Robert Bosch (SEA) Pte Ltd, 2014...