Table of Contents
Advertisement
Cable and Port Specifications
Table 8: 10/100BASE-T Management Port Cable Pinout
Pin
1
2
3
4
5
6
7
8
The following figure shows a schematic of the 10/100BASE-T cable.
Figure 17: Twisted-Pair 10/100BASE-T Cable Schematic
Supported Power Cords and Plugs
Each switch power supply unit requires one power cord. Cisco approved cords may be ordered with the
product. Standard power cords with a country specific plug can be used with wall outlets. Jumper power cords
can be used with cabinet outlets.The user may also source their own power cords for the product, as long as
they meet the power cord specifications for this product.
Note
• Only standard power cords and jumper power cords provided with the switch are supported.
• If you do not order a power cord with the system, you are responsible for selecting the appropriate power
cord for the product. Using a non-compatible power cord with this product may result in electrical safety
hazard. Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered
with the system.
Signal
TD+
TD-
RD+
RD-
Not used
Not used
Not used
Not used
Cisco MDS 9396T Multilayer Fabric Switch Hardware Installation Guide
Supported Power Cords and Plugs
57
Advertisement
Table of Contents
