Advertisement
Quick Links
GSM-EXT Cable Assembly Installation Guide
For Documentation and Online Support: http://www.security.honeywell.com/hsc/resources/MyWebTech
General Information
The GSM-EXT cable assembly is used to connect the GSMVLP5-4G/GSMVLP5CN-4G communications module installed in
the LYNX Touch or QuickConnect Touch Series control to the AlarmNet GSM-ANT external antenna assembly.
ALARMNET GSM-ANT
EXTERNAL ANTENNA
Remove the GSMVLP5-4G
1.
Unplug the power supply from the wall outlet, and open
the control panel cover.
2.
Release the front case from the back case by
depressing the two locking tabs at the top of the unit with
the blade of a medium size screwdriver.
3.
Disconnect the battery connector from the receptacle on
the PC board.
Note: Proceed to step 4 if a communications module is
already installed in the control. If this is a new
installation, proceed to step 6.
4.
Remove three screws that secure the GSMVLP5-
4G/GSMVLP5CN-4G to the control.
5.
Remove the GSMVLP5-4G/GSMVLP5CN-4G from the
LYNX Touch.
6.
Flip the GSMVLP5-4G/GSMVLP5CN-4G over and
remove two screws that secure the circuit board to the
plastic housing.
7.
Remove the circuit board from the GSMVLP5-
4G/GSMVLP5CN-4G plastic housing.
8.
Flip the circuit board over and carefully remove the PH8
Wireless Module. Take care to avoid damaging the
connector pins.
9.
Disconnect the existing antenna cable from the PH8
Wireless Module and the circuit board and discard.
Installing the GSM-EXT Cable
1.
Connect the GSM-EXT cable to the receptacle on the
PH8 Wireless Module as shown.
2.
Flip the PH8 Wireless Module over and reconnect it to
the GSMVLP5-4G/GSMVLP5CN-4G circuit board as
shown.
AlarmNet GSM-ANT External Antenna & GSM-EXT Cable
GSMVLP5-4G/
GSMVLP5CN-4G
SCREW
(3)
LOCKING TABS
ANTENNA
RECEPTACLE
PH8
WIRELESS MODULE
GSM-EXT
CABLE
GSM-EXT-010-V0
ROTATE 180
o
GSMVLP5-4G
CIRCUIT
BOARD
o
ROTATE 180
o
ROTATE 180
GSM-EXT-005-V0
SCREWS
(2)
GSM-EXT-008-V0
GSM-EXT-007-V0
GSM-EXT-006-V0
Advertisement
Related Manuals for Honeywell GSM-EXT
Summary of Contents for Honeywell GSM-EXT
- Page 1 GSM-EXT Cable Assembly Installation Guide For Documentation and Online Support: http://www.security.honeywell.com/hsc/resources/MyWebTech General Information The GSM-EXT cable assembly is used to connect the GSMVLP5-4G/GSMVLP5CN-4G communications module installed in the LYNX Touch or QuickConnect Touch Series control to the AlarmNet GSM-ANT external antenna assembly. ALARMNET GSM-ANT...
- Page 2 GSM- GSMVLP5-4G EXT cable. Route the GSM-EXT cable and secure it to the tie wrap point on the control with the provided tie wrap as shown. Mount the external antenna. Refer to the Installation Instructions provided with the AlarmNet GSM-ANT external antenna.