Numbered Standard Ipv4 Acls; Numbered Extended Ipv4 Acls - Cisco Catalyst 2960-X Security Configuration Manual
Cisco ios release 15.0(2)ex
Hide thumbs
Also See for Catalyst 2960-X:
- Command reference manual (135 pages) ,
- Hardware installation manual (34 pages) ,
- Getting started manual (25 pages)
Table of Contents
Advertisement
Configuring IPv4 ACLs
Numbered Standard IPv4 ACLs
When creating an ACL, remember that, by default, the end of the ACL contains an implicit deny statement
for all packets that it did not find a match for before reaching the end. With standard access lists, if you omit
the mask from an associated IP host address ACL specification, 0.0.0.0 is assumed to be the mask.
The switch always rewrites the order of standard access lists so that entries with host matches and entries
with matches having a don't care mask of 0.0.0.0 are moved to the top of the list, above any entries with
non-zero don't care masks. Therefore, in show command output and in the configuration file, the ACEs do
not necessarily appear in the order in which they were entered.
After creating a numbered standard IPv4 ACL, you can apply it to VLANs, to terminal lines, or to interfaces.
Numbered Extended IPv4 ACLs
Although standard ACLs use only source addresses for matching, you can use extended ACL source and
destination addresses for matching operations and optional protocol type information for finer granularity of
control. When you are creating ACEs in numbered extended access lists, remember that after you create the
ACL, any additions are placed at the end of the list. You cannot reorder the list or selectively add or remove
ACEs from a numbered list.
The switch does not support dynamic or reflexive access lists. It also does not support filtering based on the
type of service (ToS) minimize-monetary-cost bit.
Some protocols also have specific parameters and keywords that apply to that protocol.
You can define an extended TCP, UDP, ICMP, IGMP, or other IP ACL. The switch also supports these IP
protocols:
Note
ICMP echo-reply cannot be filtered. All other ICMP codes or types can be filtered.
These IP protocols are supported:
• Authentication Header Protocol (ahp)
• Encapsulation Security Payload (esp)
• Enhanced Interior Gateway Routing Protocol (eigrp)
• generic routing encapsulation (gre)
• Internet Control Message Protocol (icmp)
• Internet Group Management Protocol (igmp)
• any Interior Protocol (ip)
• IP in IP tunneling (ipinip)
• KA9Q NOS-compatible IP over IP tunneling (nos)
• Open Shortest Path First routing (ospf)
• Payload Compression Protocol (pcp)
• Protocol-Independent Multicast (pim)
OL-29048-01
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
Standard and Extended IPv4 ACLs
149
Hide quick links:
Advertisement
Table of Contents
