JVC LT-32C650 Quick Start Manual
32" led smart hd tv
Hide thumbs
Also See for LT-32C650:
- Instruction manual (56 pages) ,
- Quick start manual ,
- Quick start manual (2 pages)
Advertisement
Quick Links
Quick Start Guide
32" LED Smart HD TV
LT-32C650(A)
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your viewing
experience. We would suggest that you allow about 20 mins for initial setup.
Please follow this guide for a successful first time installation.
The latest eco-friendly power-saving technology will switch off the TV if
it is left on and idle for 4 hours. Please refer to "Auto Standby" under the
"Time Settings" section of the instruction manual for more detail.
1
Unpacking
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.
TV
R emote Control/
AAA Batteries x2
TV Stand
Screws x 4
Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.
2
Operating Your Remote Control
1. Slide open the battery compartment on the back of the remote control.
2. Insert two AAA size batteries. Make sure to match the (+) and ( - )
ends of the batteries with the (+) and ( - ) ends indicated in the battery
compartment.
3. Slide the battery compartment cover back into place. Make sure it clicks
into place.
FAV Cable
Instruction Manual
Quick Start Guide
3
Installing the Base Stand
Fitting the Stand to the TV
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table, with the back
side facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is placed beneath the screen.
3. Slide the stand under the lip, the neck will fit snugly over the screw holes. Then screw the stand to the TV using the 4 screws supplied.
LAN
SPDIF
VGA
Optic.OUT
SCART
Cushioned
Table
material
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,
or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because
the screen could crack.
4
Connecting the Aerial and Turning on the TV
1. Connect one end of the RF coaxial cable to the aerial socket on the wall
and the other end of the cable to the ANT socket on the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the button on the remote control to turn the
TV on. The LED indicator will flash for a few seconds then the TV will
switch on.
LAN
VGA
SPDIF
Coax.OUT
SCART
• Do not connect the TV to the mains supply until you have completed all the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
Slide under
Slide under
the lip
the lip
Optional
If you want to connect to the internet via a wired connection
then connect your ethernet cable to the LAN socket.
LAN
VGA
SPDIF
RF coaxial cable
Coax.OUT
(not included)
SCART
Advertisement
Related Manuals for JVC LT-32C650
Summary of Contents for JVC LT-32C650
- Page 1 Installing the Base Stand Fitting the Stand to the TV 1. Ensure the TV is switched off and not connected to the mains power supply. Quick Start Guide 2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table, with the back side facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is placed beneath the screen. 3. Slide the stand under the lip, the neck will fit snugly over the screw holes. Then screw the stand to the TV using the 4 screws supplied. 32" LED Smart HD TV LT-32C650(A) Thank you SPDIF for purchasing your new JVC TV. Optic.OUT SCART Your new TV incorporates the latest technology to enhance your viewing experience. We would suggest that you allow about 20 mins for initial setup. Please follow this guide for a successful first time installation. Slide under Slide under the lip...
- Page 2 WIRELESS Connection You can connect using a wireless connection via your router. 1. Press the buttons to select WIRELESS DEVICE. Wait a few seconds and a list of all wireless networks will be displayed. 2. Press the buttons to select your wireless network then press OK. Need More Help! 3. You now need to enter your password, a keyboard will appear. Press the buttons to select a letter/number/symbol and press OK to enter each one. Once you have typed your password highlight OK and press OK. The network will now show Connected. If you need more help setting up your TV then please call: UK: 0344 561 1234 Ireland: 1890 818 575 4. Press the OK button to continue. Lines are open 24/7 Well done, your new TV is now ready to use. You will find that there are many exciting features available. To get to know all these features, please take some time to read the instruction manual provided with your TV. (QSG-LT-32C650(A)-150827V1)