Table of Contents
Advertisement
Setting up a Multiservices Platform Series Device
Identify the two brackets that are labeled B and take these actions for each bracket:
Step 2
a.
b.
Releasing the Inner Rails
You must release the inner rails before you can attach them to the Multiservices Platform Series device.
To do so, see
Figure 2-3
Procedure
Pull the inner rail out until it is fully extended.
Step 1
Press the inner rail locking tab down.
Step 2
Remove the inner rail from the rail assembly.
Step 3
Repeat these steps for the other inner rail.
Step 4
Cisco Physical Security Multiservices Platform Series User Guide
2-6
Place one of the brackets inside of the rack and align the holes in the bracket with the holes on the
rear of the rack at the same height that you installed the "A" brackets.
Make sure that the "Inward" stamp on the bracket faces toward the inside of the rack.
Attach the bracket to the rack using two M5 x 12 screws, provided.
Drive the screws through the rack and then into the bracket. Make sure to securely tighten the
screws.
Figure 2-3
and perform the procedure that follows.
Extending and Releasing the Inner Rail (Left Rail Assembly Shown)
Chapter 2
Setting Up and Maintaining the Multiservices Platform Series Device
OL-21838-03
Hide quick links:
Advertisement
Table of Contents
