Table of Contents
Advertisement
Implementing Multicast Routing on Cisco IOS XR Software
Configuring the mLDP User Interface for LDP Opaque Static ID Using the Routing Policy
SUMMARY STEPS
1. configure
2. route-policy mldp_policy
3. if mldp opaque static-id 32-bit decimal number then pass endif
4. end-policy
5. commit
6. Use the show command to verify the configuration: show running-config route-policy mldp_policy
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
route-policy mldp_policy
Example:
RP/0/RP0/CPU0:router(config)#route-policy
mldp_policy
Step 3
if mldp opaque static-id 32-bit decimal number then pass
endif
Example:
RP/0/RP0/CPU0:router(config-rpl)# if mldp opaque
static-id then pass endif
Step 4
end-policy
Example:
RP/0/RP0/CPU0:router(config-rpl)# end-policy
Step 5
commit
Step 6
Use the show command to verify the configuration: show
running-config route-policy mldp_policy
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
Multipoint Label Distribution Protocol Route Policy Map
Purpose
Enters global configuration mode.
Enters the Route-policy configuration mode, where
you can define the route policy.
Configures the mLDP static id to the specific static
id.
An example output is as shown below:
Wed Jun 18 11:41:09.333 IST
route-policy mldp_policy
if mldp opaque static-id 10 then
pass
endif
end-policy
!
47
Advertisement
Table of Contents
