Redistribute Lisp Route-Map - Cisco Nexus 7000 Series Command Reference Manual
Nx-os lisp command reference
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
redistribute lisp route-map
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
redistribute lisp route-map
To configure Border Gateway Protocol (BGP) running on a Locator/ID Separation Protocol (LISP) Map
Server to redistribute and advertise EID-prefixes from registered LISP sites, use the redistribute lisp
route-map command. To remove the configuration, use the no form of this command.
Syntax Description
route-map
None
Defaults
BGP configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History
Release
5.0(1.13)
When a Map Server registers LISP sites, the EID-prefixes from these registered LISP sites are advertised
Usage Guidelines
through BGP into the virtual routing and forwarding (VRF) instance that is used by the Locator/ID
Separation Protocol Alternative Topology (LISP-ALT). This action can be accomplished by using the
redistribute lisp route-map command.
Only after an egress tunnel router (ETR) successfully registers through the Map-Registration process,
the EID-prefixes from that LISP site are advertised in the URIB or U6RIB by the LISP process. BGP
then redistributse the EID-prefixes, according to the route-map rules, into the LISP-ALT.
Note
•
•
This command does not require a license.
This example shows how to configure redistribution of registered LISP site EID-prefixes, according to
Examples
the rules of the route-map Valid-LISP:
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-150
redistribute lisp route-map route-map
no redistribute lisp route-map route-map
Route map.
Modification
This command was introduced.
We recommend that you use the route-tag under the eid-prefix command to simplify redistributing
EID-prefixes into BGP.
You must connect the Map Server to the LISP-ALT. For more information, see the ip lisp alt-vrf
and ipv6 lisp alt-vrf command.
Cisco Nexus 7000 Series LISP Commands
Advertisement
Table of Contents
