Related Manuals for Sealey SL65S.V2
Summary of Contents for Sealey SL65S.V2
- Page 1 Model: Sl65S.V2 Jump Starter oWNeR’S MANUAl SL65S.V2 Issue: 1 08/12/17 Original Language Version © Jack Sealey Limited...
- Page 2 1.7 Use only recommended attachments. Use of an attachment not recommended or sold by Sealey for the SL65S may result in a risk of fire, electric shock or injury to persons or damage to property. 1.8 To reduce the risk of damage to the electric plug or cord, pull by the adaptor rather than the cord when disconnecting the unit.
-
Page 3: Personal Precautions
1.15 Never place the unit directly above battery being jumped. 1.16 Do not use the unit to jump start a vehicle while charging the internal battery. 2. PERsOnAl PRECAUTiOns WARning! RisK OF EXPlOsiVE gAsEs. A sPARK nEAR ThE BATTERY MAY CAUsE A BATTERY EXPlOsiOn. TO REDUCE ThE RisK OF A sPARK nEAR ThE BATTERY: 2.1 NEVER smoke or allow a spark or flame in the vicinity of a battery or engine. -
Page 4: Preparing To Use The Unit
3. PREPARing TO UsE ThE UniT WARning! RisK OF COnTACT WiTh BATTERY ACiD. BATTERY ACiD is A highlY CORROsiVE sUlFURiC ACiD. 3.1 Make sure the area around the battery is well ventilated while the unit is in use. 3.2 Clean the battery terminals before using the jump starter. During cleaning, keep airborne corrosion from coming into contact with your eyes, nose and mouth. - Page 5 • SL65S jump starter • Carrying case • Battery clamps • Owners manual with smart cable 6. FEATUREs 1. SL65S.V2 8. Input socket for recharging 2. Battery clamps 9. USB port – 2.1A with smart cable 10. USB port – 1A 3.
-
Page 6: Charging The Internal Battery
ChARging ThE inTERnAl BATTERY NoTe: For best results, use a 2A micro USB-USB cable to charge. NoTe: Use a 2A USB charger (sold separately), or a 2A USB charging port to quickly recharge the jump starter. Using a charger with less than 2A will increase charge time. 1. - Page 7 smart cable. When the condition is corrected, the smart cable will automatically reset. 7. After a proper connection has been made, crank the engine. If the engine does not start within 5-8 seconds, stop cranking and wait at least 1 minute before attempting to start the vehicle again.
-
Page 8: Maintenance Instructions
• Flash in strobe mode 4. When finished using the LED light, press and hold the display button until the light turns off. 5. Slide the ON/OFF switch to the OFF position. 6. Recharge the unit as soon as possible after each use. 9. -
Page 9: Specifications
• The battery must be disposed of safely. Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. -
Page 10: Environment Protection
Contact your local solid waste authority for recycling information. Parts support is available for this product. Please contact: email sales@sealey.co.uk or telephone 01284 757500. NOTE: It is our policy to improve products continually and as such we reserve the right to alter data, specifications and component parts without prior notice.