Table of Contents
Advertisement
RP-U200
5. V-MAX
Sets the main volume to 0dB.
6. V-MID60
Sets the main volume to -20dB.
7. V-MID55
Sets the main volume to -25dB.
8. V-MID52
Sets the main volume to -28dB.
9. V-MID49
Sets the main volume to -31dB.
10. V-MID29
Sets the main volume to -51dB.
11. V-MID1
Sets the main volume to -79dB.
12. V-MIN
Sets the main volume to -80dB.
13. RETURN
Returns the menu to the main menu (5. AD).
6. USB
(USB loop back test)
1. START [Remote control code : 7B—1C (A)]
Starts the loop back of USB.
2. STOP [Remote control code : 7B—1D (B)]
Stops the loop back of USB.
3. RETURN
Returns the menu to the main menu (6. USB).
* This menu is used for the factory inspection before
shipping.
11
7. INIT
(Memory initialization)
1. MEMORY (Memory reset reservation)
Reserves the backup RAM to be reset to the factory
setting before shipping.
Procedure
1) Using the DIAG function, have "7. INIT" displayed.
2) Press the DSP key. ("MEMORY" on display)
3) Press the DSP key again. ("DONE" on display)
4) Press the DOWN (q) key. ("RETURN" on display)
5) Press the DSP key. ("7. INIT" on display)
6) Press the UP (w) key a few times to have "0.EXIT" dis-
played.
7) Turn off the power by pressing the DSP key.
The actual initialization is executed when the DIAG function
is cancelled and the power is turned on.
For the contens of the initialization, see page 14.
2. CANCEL (Cancellation of memory reset reservation)
Makes the memory reset reservation invalid. RAM
initialization is not executed.
3. RETURN
Returns the menu to the main menu (7. INIT).
8. VER
(Version information)
1. SHV
Displays the version information of the microcomputer
(IC436).
The final alphabet indicates the version of the boot area. If
the rewrite version is different, it is not transmitted
properly.
2. EGAV
Displays the version information of the gate array (IC475:
LC27287B).
3. ChckSum
Displays the checksum information of the microcomputer
(IC436).
4. RETURN
Returns the menu to the main menu (8.VER).
Advertisement
Table of Contents
