Cisco Catalyst 3850 Deployment Manual page 31

Hide thumbs Also See for Catalyst 3850:

Table of Contents

To assign the active and standby roles to specific switches, configure the default switch priority for all switches in

the stack. You configure the priority once, usually during the initial configuration process, but you can change the

configuration at any time. The configured switch priorities are immediately set in the boot loader configuration of

each switch in the stack. This means the switch priority configuration cannot be verified from the startup or running

configuration because it is programmed into different configuration components. The switch priority configuration in

boot loader is parsed during the boot cycle, not read from the startup configuration stored in NVRAM.

To modify the default switch priority, use these EXEC commands:

This example shows the priority of each switch and its role:

Page 31 of 54

Table of Contents