Cisco Unified Access CT5760 Deployment Manual page 27

Web gui

Table of Contents

You can configure SNMP trap in this section, give a Location and Contact to proceed to next step.

Step 38

Management Interface Configuration—You can use the out of band Management Port to access the

Step 39

switch. Enter the IP address/Netmask shown in the screen below and proceed to next screen for

Wireless management configuration.

Wireless Management Configuration—Here, you can configure Wireless Management interface on the

Step 40

3850 and assign it for a specific VLAN. Assign VLAN IP and default gateway.

AP is connected to Interface Gig1/0/3 marked as access port.

Note

Cisco Unified Access CT5760 Controllers and Catalyst 3850 Switches Web GUI Deployment Guide, Cisco IOS XE Software Release 3.2.2

Configuration Examples

Table of Contents

Catalyst 3850