Configuring Mpls-Tp Links And Physical Interfaces - Cisco ASR 900 Series Manual
Mpls basic configuration guide, cisco ios xe everest 16.5.1
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Configuration manual (172 pages) ,
- Configuration manual (6 pages)
Table of Contents
Advertisement
MPLS Transport Profile
Command or Action
Step 6
exit
Example:
Device(config-mpls-tp-lsp-forw)# exit
Step 7
reverse-lsp
Example:
Device(config-mpls-tp-lsp)# reverse-lsp
Step 8
in-label num out-label num out-link num
Example:
Device(config-mpls-tp-lsp-rev)# in-label 22000
out-label 20000 out-link 44
Step 9
end
Example:
Device(config-mpls-tp-lsp-rev)# end
Configuring MPLS-TP Links and Physical Interfaces
MPLS-TP link numbers may be assigned to physical interfaces only. Bundled interfaces and virtual interfaces
are not supported for MPLS-TP link numbers.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. ip address ip-address mask
5. mpls tp link link-num{ipv4 ip-address tx-mac mac-address}
6. end
DETAILED STEPS
Command or Action
Step 1
enable
Purpose
Enables privileged EXEC mode.
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Configuring MPLS-TP Links and Physical Interfaces
Purpose
Exits MPLS-TP LSP forward LSP configuration
mode.
Enters MPLS-TP LSP reverse LSP configuration
mode.
Specifies the in-label, out-label, and out-link
numbers.
Exits the MPLS TP LSP configuration mode and
returns to privileged EXEC mode.
31
Advertisement
Table of Contents
Troubleshooting
