User Manual for AyAlarm
V2.1
•
Notifiers
– to configure the alarm notifiers of this mode. For details see the chapter 5.4.3.
•
Triggers
– to configure the alarm triggers of this mode. For details see the chapter 5.4.4.
•
Duration (except the "Voice Call" mode)
– to configure the time period while the mode should remain in alarm state since the alarm
was triggered
•
Overview
– to have an overview of all settings for the selected mode
In the mode menu screen the mode name is displayed as title. No status icons are displayed in this
screen. The scroll bar is always shown.
As long as no mode is started the green LED will blink. This means that in main and mode menu
the green LED is blinking.
The available buttons and screen's functionality are the same as in every menu screen.
5.4Configuring a mode
All modes are configurable via the AyTerminal and also via the AyServer GUI. The AyAlarm
application allows activating / deactivating and configuring a set of sensors (named alarm triggers)
with threshold values and operators when to trigger an alarm and the notifiers when an alarm is
triggered. In order to be able to start a mode, at least one trigger must be activated. The notifiers of
a mode can be deactivated. In this case before the mode is started a warning message will be
displayed.
5.4.1Activation Time
From the "Activation time" menu it is possible to:
•
enable the activation time. This means that the mode will be active only for the defined
period of time (e.g. 1 hour, between 10:30 and 11:30). In this case when the end time is
reached the mode becomes idle.
•
define the activation start time (see next section) (e.g. 10:30)
•
define the activation end time for a mode on a daily basis (see the next section) (e.g. 11:30)
Upon selecting one of the "Start" or "End" menu items, the time can be entered in a time editor.
The time format is 24h.
The colons are displayed after the second and fifth digits are inserted.
For adding a new digit in the input area navigate through the displayed characters (right side of the
screen) using the up/ down navigation buttons until the needed character is selected and then
press the enter button (OK button).
To leave one of the two previous screens and to set the value, first select OK and then press the
enter button (OK button).
Activation time
Active
Start
End
Figure 5-21 Activation time menu
Start time
OK
12:00:00
Figure 5-22 Activation time – Set start time screen
Activation t
Active
Start
End
Start time
0
12:00:
1
2
AyTerminal
AyAlarm application