Compact Plain Paper FAX Model No. KX-FM106 OPERATING INSTRUCTIONS Please read these Operating Instructions before using the unit and save for future reference.
Thank you for purchasing a Panasonic facsimile. Welcome to the world of Panasonic facsimiles. This product combines facsimile, telephone, copier, scanner, PC Fax and printer features to provide you with more efficient office or home use. By utilizing these convenient features, you can maximize the effectiveness of this unit.
Important safety instructions! When using this unit, basic safety precautions D. If the unit does not work normally by following should always be followed to reduce the risk of fire, the operating instructions. Adjust only controls electric shock, or personal injury. covered by the operating instructions.
Page 5
The free starter film cartridge is only 20 meters (65p) long. We recommend that you buy regular film cartridge [100 m (328p)] for continuous use of your unit. For best results, use genuine Panasonic film cartridge Model No. KX-FA65. To stack printed paper, use a paper stacker Model No. PFZXFP101M (p. 6, 7).
Page 6
Overview! Document guides Recording paper entrance Document entrance Paper tray Document feeder tray Cover open button Speaker Recording paper exit Serial interface connector (Used to connect your PC Cover with a RS232C cable.) Document exit Note: ≥The document and recording paper will be ejected from the front of the unit. Install the unit on a desk or floor with a smooth surface and do not place anything in front of the unit.
Page 7
Paper tray! Insert the two tabs on the paper tray into the slots on the Paper tray back of the unit. Tabs ≥Do not place the unit in areas where the paper tray may be obstructed by a wall, etc. Slots Paper stacker!
Using legal size paper Press the dotted area on the paper stacker Dotted area extender. Paper stacker extender Open the paper stacker extender. Paper stacker extender Recording paper! Letter or legal size recording paper can be loaded. The paper tray can hold up to 150 sheets of 75 (20 lb.) paper.
Page 9
Pull the tension bar forward and hold open while inserting the paper. ≥The height of the stack of the paper should not exceed the upper limit on the paper tray, otherwise Upper the paper may jam or multi-feed. limit ≥The paper should not be over the tab. ≥If the paper is not inserted correctly, readjust the paper or the paper may jam.
Page 10
Connections! Connect the handset cord. Connect the telephone line cord. Connect the power cord. ≥The unit will automatically start to detect the dialing mode of your telephone line (see below). ≥When the power is turned on for the first time, the unit will print some basic information.
Page 11
Location! To select a resolution. To scan and store a document into memory, and then transmit or copy the stored document. To adjust volumes. To send faxes using the IQ-FAX function. To select feature settings during programming. To print a quick For voice muting.
Page 12
For the Caller ID service. For transmission to multiple stations. For the One-Touch Dial. Command keys. AUTO ANSWER To turn the auto answer mode on/off. FAX ON To insert a hyphen. CALLER ID SEARCH To insert one character or one space. To keep the telephone number secret.
Telephone Protection Act of 1991. Your logo Your facsimile telephone number Date and time Example: FROM : Panasonic Fax FAX NO. : 1234567 Feb. 26 1999 04:02PM Fax Correspondence Setting the date and time Press (MENU).
Setting your logo The logo can be your company, division or name. Press (MENU). HYPHEN Display: 1.SYSTEM SET UP INSERT MENU Press (#), then (0) (2). YOUR LOGO Press (START/SET/COPY). LOGO= Enter your logo, up to 30 characters, by using the dial keypad.
Page 15
To select characters with the dial keypad Pressing the dial keys will select a character as shown below. Keys Characters – " & ¥ ’ HYPHEN key (To insert a hyphen.) INSERT key (To insert one character or one space.) Delete key (To delete a character.) STOP key (To move the cursor to the left.)
Setting your facsimile telephone number Press (MENU). HYPHEN MENU Display: 1.SYSTEM SET UP Press (#), then (0) (3). YOUR FAX NO. Press (START/SET/COPY). NO.= Enter your facsimile telephone number up to 20 digits using the dial keypad. STOP Example: NO.=1234567 START/SET/COPY Press (START/SET/COPY).
Voice calls - making! Press (MONITOR) or lift the handset. Display: TEL= Dial the telephone number. HANDSET MUTE Handset Example: TEL=2345678 ≥If you misdial, hang up and dial again. When the other party answers, speak with the handset. When finished talking, replace the handset. MONITOR REDIAL/PAUSE To redial the last number...
Voice calls - answering! When the unit rings, lift the handset. HANDSET MUTE When finished talking, replace the handset. Handset Ringer volume 4 levels (high/middle/low/off) are available. While the unit is idle, press (›) or (‹). To turn the ringer off: 1.
Making a copy The unit can make single or multiple copies (up to 99). Any transmittable document (p. 19) can be copied. Open the document feeder tray. Document Document guides feeder tray Adjust the width of the document guides to the size of the document.
Sending a fax manually! Document Open the document feeder tray. Document guides feeder tray Adjust the width of the document guides to the size of the document. Insert the document (up to 15 pages) FACE DOWN until a single beep is heard and the unit grabs the document.
Setting the unit to receive calls! Allows you to answer all voice and fax calls AUTO ANSWER FAX ON yourself. When the unit rings, you must answer all calls. TEL mode ≥If you hear a fax calling tone (slow beep) or no sound is heard, press (START/SET/COPY).
Receiving documents manually! When the unit rings, lift the handset to answer the call. When: Handset — document reception is required, — a fax calling tone (slow beep) is heard, or — no sound is heard, press (START/SET/COPY). CONNECTING..Replace the handset. ≥The unit will start reception.
Information! Connecting to a computer 25 Pin Male COM port 9 Pin Female RS232C cable (Included) Use a 25 Pin Adaptor if your PC has a 25 pin com port. Installing the Multi-Function Center software Start Windows 3.1/3.11/95/98 and close all applications. Insert the CD into your CD-ROM drive.
Page 24
List of FCC requirements and information! If required by the telephone company, inform them alteration of such terminal equipment, or otherwise of the following. materially affect its use or performance, the FCC Registration No.: customer shall be given adequate notice in writing, (found on the rear of the unit) to allow the customer an opportunity to maintain Ringer Equivalence No.:...
Or call, toll free, 1-800-HELP FAX (1-800-435-7329) to locate a PASC Factory Servicenter. Carry-in or mail-in service in Puerto Rico can be obtained during the warranty period by calling the Panasonic Sales Company telephone number listed in the Servicenter Directory.
Page 26
Hollywood, FL 33020 Fax (808) 486-4369 Service in Puerto Rico Matsushita Electric of Puerto Rico, Inc. Panasonic Sales Company/ Factory Servicenter: Ave. 65 de Infantería, Km. 9.5, San Gabriel Industrial Park, Carolina, Puerto Rico 00985 Phone (787) 750-4300 Fax (787) 768-2910...
Page 27
Attach a letter, detailing the symptom or problem, to the outside of the carton. Send the unit to an authorized servicenter, prepaid and adequately insured. Do not send your unit to the Panasonic Consumer Electronics Company or to any executive or regional sales offices. These locations do not repair consumer products.
Page 28
Technical data about this product! Applicable Lines: Public Switched Telephone Network Document Size: Max. 216 mm (8 " ) in width Max. 600 mm (23 " ) in length Effective Scanning Width: 208 mm (8 " ) × 279 mm (8 "...
Page 29
Panasonic Sales Company, Company, Division of Matsushita Division of Matsushita Electric of Electric Corporation of America Puerto Rico, Inc. (“PSC”) One Panasonic Way, Secaucus, Ave. 65 de Infantería, Km. 9.5 New Jersey 07094 San Gabriel Industrial Park, Carolina, Puerto Rico 00985...