Configuring The Access Point For The First Time - Cisco Aironet 1240AG Series Hardware Installation Manual
Hide thumbs
Also See for Aironet 1240AG Series:
- Hardware installation manual (126 pages) ,
- Quick start manual (49 pages) ,
- Datasheet (10 pages)
Table of Contents
Advertisement
Configuring the Access Point for the First Time
This chapter describes how to configure basic settings on your access point for the first time. The
contents of this chapter are similar to the instructions in the quick start guide that shipped with your
access point. You can configure all the settings described in this chapter using the CLI, but it might be
simplest to browse to the access point's web-browser interface to complete the initial configuration and
then use the CLI to enter additional settings for a more detailed configuration.
This chapter contains these sections:
Before You Start, page 3-2
•
Obtaining and Assigning an IP Address, page 3-3
•
Connecting to the Access Point Locally, page 3-4
•
Assigning Basic Settings, page 3-5
•
•
Enabling the Radio Interfaces, page 3-8
Finding the IP Address Using the CLI, page 3-13
•
•
Assigning an IP Address Using the CLI, page 3-14
Using a Telnet Session to Access the CLI, page 3-14
•
OL-7293-01
D r a f t 1 A - C I S C O C O N F I D E N T I A L
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
C H A P T E R
3
3-1
Advertisement
Table of Contents
Troubleshooting
