Debug Lacp - Cisco Catalyst 2960-X Command Reference Manual
Layer 2
Hide thumbs
Also See for Catalyst 2960-X:
- Security configuration manual (498 pages) ,
- Hardware installation manual (34 pages) ,
- Getting started manual (25 pages)
Table of Contents
Advertisement
Layer 2 Commands
debug lacp
To enable debugging of Link Aggregation Control Protocol (LACP) activity, use the debug lacp command
in privileged EXEC mode. To disable LACP debugging, use the no form of this command.
debug lacp[all| event| fsm| misc| packet]
nodebug lacp[all| event| fsm| misc| packet]
Syntax Description
all
event
fsm
misc
packet
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS 15.0(2)EX
Usage Guidelines
The undebug etherchannel command is the same as the no debug etherchannelcommand.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable debugging
on a stack member, start a session from the stack master by using the session switch-number command in
privileged EXEC mode. Enter the debug command at the command-line prompt of the stack member.
To enable debugging on a stack member without first starting a session on the stack master, use the remote
command switch-number LINE command in privileged EXEC mode.
Examples
This example shows how to display all LACP debug messages:
Switch# debug LACP all
This example shows how to display debug messages related to LACP events:
Switch# debug LACP event
OL-29043 -01
(Optional) Displays all LACP debug messages.
(Optional) Displays LACP event debug messages.
(Optional) Displays messages about changes within the LACP finite state machine.
(Optional) Displays miscellaneous LACP debug messages.
(Optional) Displays the receiving and transmitting LACP control packets.
Modification
This command was introduced.
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
debug lacp
31
- Quick Links:
- Layer 2 Commands
Hide quick links:
Advertisement
Table of Contents
