hit counter script

Port And 4-Port Oc-3C/Stm-1 Pos Spa Overview - Cisco ASR-1000-SIP10 Hardware Installation Manual

Asr 1000 series aggregation services routers sip and spa
Table of Contents

Advertisement

Chapter 3
Overview: Cisco ASR 1000 Series Aggregation Services Routers Shared Port Adapters

2-Port and 4-Port OC-3c/STM-1 POS SPA Overview

The 2-Port and 4-Port OC-3c/STM-1 POS SPA is a single-height SPA that installs into one SIP subslot.
The 2-Port and 4-Port OC-3c/STM-1 POS SPA with small form-factor pluggable (SFP) optical
transceiver modules provides SONET and SDH network connectivity with a per-port bandwidth of
155.52 Mbps. The 2-Port and 4-Port OC-3c/STM-1 POS SPA operates at quarter rate.
When SFP modules are replaced, the SPA interface retains any previously defined configurations. These
Note
configurations include settings for IP address, clock source, loopback, CRC, and POS flags.
For more information about SPAs and their compatibility with SIPs and modular optics, see the
and SPA Compatibility" section on page
The following sections describe the 2-Port and 4-Port OC-3c/STM-1 POS SPA:
2-Port and 4-Port OC-3c/STM-1 POS SPA LEDs
The 2-Port and 4-Port OC-3c/STM-1 POS SPA has three types of LEDs: two LEDs for each port on the
SPA, and one STATUS LED, as shown in
Figure 3-22
1
2
Table 3-26
Table 3-26
LED Label
C/A
OL-14126-03
2-Port and 4-Port OC-3c/STM-1 POS SPA LEDs, page 3-31
2-Port and 4-Port OC-3c/STM-1 POS SPA Interface Specifications, page 3-32
2-Port and 4-Port OC-3c/STM-1 POS SPA Optical Transceiver Modules and Cables, page 3-32
4-Port OC-3c/STM-1 POS SPA Faceplate
1
2
C/A (Carrier/Alarm) LED
A/L (Active/Loopback) LED
describes the 2-Port and 4-Port OC-3c/STM-1 POS SPA LEDs.
2-Port and 4-Port OC-3c/STM-1 POS SPA LEDs
Color
State
Off
Off
Green
On
Amber
On
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
2-Port and 4-Port OC-3c/STM-1 POS SPA Overview
1-2.
Figure
3-22.
STATUS LED
3
Meaning
SONET controller is shut down.
Port is enabled by software, and there is a valid SONET signal
without any alarms.
Port is enabled by software, and there is at least one alarm.
"SIP
3
3-31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents