Table of Contents
Advertisement
Cable and Port Specifications
This appendix includes the cables and connectors used with the Cisco MDS 9132T Multilayer Fabric Switch.
We strongly recommend that power cable runs and other potential noise sources be located as far away
Caution
as practical from network cabling that terminates on Cisco equipment. In situations where long parallel
cable runs exist but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these
potential noise sources. To avoid interference, the source should be shielded by housing it in a grounded
metallic conduit.
•
•
•
•
Cables and Adapters
The Cisco MDS 9132T Switch accessory kit includes the following:
• RJ-45 to RJ-45 rollover cable
• RJ-45 to DB-9 female DTE adapter (labeled "Terminal")
• RJ-45 to DB-25 female DTE adapter (labeled "Terminal")
• RJ-45 to DB-25 male DCE adapter (labeled "Modem")
Note
Additional cables and adapters can be ordered from your customer service representative.
Cables and Adapters, page 65
Console Port, page 66
MGMT 10/100/1000 Ethernet Port, page 68
Supported Power Cords and Plugs, page 70
A P P E N D I X
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
A
65
Hide quick links:
Advertisement
Table of Contents
