Table of Contents
Advertisement
IP Camera Physical Details
Back View
Figure 1-2
Figure 1-2
1
1
2
3
4
5
Cisco Video Surveillance 6400E IP Camera Installation Guide
1-4
and the table that follows describe the back view of the 6400E IP camera.
Back View of IP Camera
General Purpose I/O (GPIO)
terminal block
SD/SDHC card slot
Video output switch
Focus assist button
Reset button
2
3
4
5
6
7
GPIO terminal block that is used to connect external input and
output devices. For more information, see
The IP camera is compliant with Micro SD/SDHC (up to 32GB)
and other preceding standard SD cards.
Switches the video output between to following standards:
NTSC 60Hz (up)—switches camera operation to the
•
National Television System Committee (NTSC) standard.
PAL 50Hz (down)—switches camera operation to the
•
Phase Alternating Line (PAL) standard.
Used in conjunction with an analog display to fine tune the IP
camera focus.
Reboots the IP camera or resets it to a default state. Depending
on how long you depress the reset button, you can do either of
the following:
Reset—Press and release the reset button. Wait for the IP
•
Camera to reboot.
Restore—Press and hold the reset button for about
•
30 seconds. All settings will be restored to factory default.
Chapter 1
Overview
Figure
1-3.
OL-32282-01
Advertisement
Table of Contents
