Removing And Replacing The Supervisor Engine - Cisco Catalyst 5000 Series Installation And Configuration Note
Route switch feature card
Hide thumbs
Also See for Catalyst 5000 Series:
- Manual (33 pages) ,
- Installation and configuration note (18 pages) ,
- Product support bulletin (6 pages)
Table of Contents
Advertisement
Required Tools and Equipment
Required Tools and Equipment
These tools are required to install the RSFC:
•
•
•
Removing and Replacing the Supervisor Engine
Note
Supervisor Engine II Gs or both Supervisor Engine III Gs.
Note
are installed, hot swapping allows you to remove and replace one of the supervisor engines without
turning off the system power.
These sections describe how to remove and replace the supervisor engine:
•
•
•
Avoiding Problems When Inserting and Removing Modules
The ejector levers on the supervisor engine align and seat the supervisor engine connectors in the
backplane. See Figure 1. If you fail to use the ejector levers to insert the supervisor engine, you can
disrupt the order in which the pins make contact with the backplane. When removing a supervisor
engine, use the ejector levers to ensure that the supervisor engine connector pins disconnect from the
backplane properly. Any supervisor engine that is only partially connected to the backplane can
disrupt the system.
8 Catalyst 5000 Series Route Switch Feature Card Installation and Configuration Note
Phillips-head screwdriver
Flat-head screwdriver
ESD wrist or ankle strap
To support supervisor engine redundant operation, the supervisor engines must be either both
Catalyst 5505, Catalyst 5509, and Catalyst 5500 switches—When two supervisor engines
Avoiding Problems When Inserting and Removing Modules, page 8
Removing the Supervisor Engine, page 9
Installing the Supervisor Engine, page 10
Advertisement
Chapters
Table of Contents
