Table of Contents
Advertisement
Configuring the Switch
S e n d f e e d b a c k t o n e x u s 4 K - d o c f e e d b a c k @ c i s c o . c o m
Figure 3
In the New Static IP Configuration area, enter the new IP address, the Subnet mask, and the Gateway
Step 9
address. Click Save.
Note
Click the Advanced Configuration link. Take the following actions for switch module features:
Step 10
a.
b.
Note
(Optional) To begin a Telnet session to the switch module, click the Start Telnet Session link. Click
Step 11
Start Telnet.
Click Save to save your settings. Exit the AMM web interface.
Step 12
Initial Setup
To enter the basic configuration parameters, perform the following steps:
Step 1
Open the AMM and configure the IP address, subnet mask, and gateway address for the management
interface (mgmt1), as described in
Step 2
Telnet to the mgmt1 IP address and log in using the following (default) user ID and password:
•
•
You can now configure the switch module.
Cisco Nexus 4001I and 4005I Switch Module for IBM BladeCenter Getting Started Guide
6
AMM I/O Module Configuration Window
The Save button is located in the lower, right portion of the window.
Enable external management for all ports.
Preserve the new IP configuration on all resets.
These features are disabled, by default.
Login ID is USERID.
Password is PASSW0RD (the 0 in PASSW0RD is a zero).
"Assigning the IP Address on the switch module" section on page
4.
OL-19952-02
Advertisement
Table of Contents
