Displaying Mvr Information - Cisco Catalyst 2975 Software Configuration Manual

Ios release 12.2(55)se

Hide thumbs Also See for Catalyst 2975:

Table of Contents

Configuring IGMP Snooping and MVR

Displaying MVR Information

You can display MVR information for the switch or for a specified interface. Beginning in privileged

EXEC mode, use the commands in

Commands for Displaying MVR Information

show mvr interface [interface-id]

[members [vlan vlan-id]]

show mvr members [ip-address] Displays all receiver and source ports that are members of any IP multicast group or the

Displays MVR status and values for the switch—whether MVR is enabled or disabled,

the multicast VLAN, the maximum (256) and current (0 through 256) number of

multicast groups, the query response time, and the MVR mode.

Displays all MVR interfaces and their MVR configurations.

When a specific interface is entered, displays this information:

Type—Receiver or Source

Status—One of these:

Active means the port is part of a VLAN.

Up/Down means that the port is forwarding or nonforwarding.

Inactive means that the port is not part of any VLAN.

Immediate Leave—Enabled or Disabled

If the members keyword is entered, displays all multicast group members on this port or,

if a VLAN identification is entered, all multicast group members on the VLAN. The

VLAN ID range is 1 to 1001 and 1006 to 4094.

specified IP multicast group IP address.

to display MVR configuration:

Catalyst 2975 Switch Software Configuration Guide

Displaying MVR Information

Show Quick Links

Table of Contents