Cisco Catalyst 3650 Series Configuration Manual page 28
Wlan configuration guide, cisco ios xe release 3e
Hide thumbs
Also See for Catalyst 3650 Series:
- Command reference manual (1108 pages) ,
- Hardware installation manual (126 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
Configuring the Switch Web GUI
•
If Mobility Agent is chosen, enter the mobility controller IP address in the Mobility Controller IP Address
text box and mobility controller IP address in the Mobility Controller Public IP Address text box.
• If Mobility Controller is chosen, then the mobility controller IP address and mobility controller public IP
address are displayed in the respective text boxes.
• Displays mobility protocol port number in the Mobility Protocol Port text box.
• Displays the mobility switch peer group name in the Mobility Switch Peer Group Name text box.
• Displays whether DTLS is enabled in the DTLS Mode text box.
DTLS is a standards-track Internet Engineering Task Force (IETF) protocol based on TLS.
• Displays mobility domain identifier for 802.11 radios in the Mobility Domain ID for 802.11 radios text box.
• The amount of time (in seconds) between each ping request sent to an peer switch in the Mobility Keepalive Interval
(1-30)sec text box.
Valid range is from 1 to 30 seconds, and the default value is 10 seconds.
• Number of times a ping request is sent to an peer switch before the peer is considered to be unreachable in the
Mobility Keepalive Count (3-20) text box.
The valid range is from 3 to 20, and the default value is 3.
• The DSCP value that you can set for the mobility switch in the Mobility Control Message DSCP Value (0-63) text
box.
The valid range is 0 to 63, and the default value is 0.
• Displays the number of mobility switch peer group member configured in the Switch Peer Group Members
Configured text box.
The WLANs page appears.
Step 11
In the WLANs page, enter the following WLAN configuration parameters, and click Next.
• WLAN identifier in the WLAN ID text box.
• SSID of the WLAN that the client is associated with in the SSID text box.
• Name of the WLAN used by the client in the Profile Name text box.
The 802.11 Configuration page appears.
Step 12
In the 802.11 Configuration page, check either one or both 802.11a/n/ac and 802.11b/g/n check boxes to enable the
802.11 radios, and click Next.
The Set Time page appears.
Step 13
In the Set Time page, you can configure the time and date on the switch based on the following parameters, and click
Next.
• Displays current timestamp on the switch in the Current Time text box.
• Choose either Manual or NTP from the Mode drop-down list.
On using the NTP server, all access points connected to the switch, synchronizes its time based on the NTP server
settings available.
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
18
Using the Web Graphical User Interface
OL-32353-01
Hide quick links:
Advertisement
Table of Contents
