Cisco Firepower 4100 Series Hardware Installation Manual page 56

Hide thumbs Also See for Firepower 4100 Series:

Table of Contents

Install the FIPS Opacity Shield

Step 4

Attach a cable management bracket to each slide rail locking bracket using the four 8-32 x .375" countersink Phillips

head screws provided in the accessory kit.

Figure 37: Attach the Cable Management Bracket to the Slide Rail Locking Bracket

Cable management bracket

8-32 x .375" countersink Phillips head screws

(2 per side)

Step 5

Connect the cables to the ports. See

procedure.

If you are installing the FIPS opacity shield after the initial product installtion, the cables will already be connected. If

the attached cables do not have enough slack to route them through the cable mounting brackets (as shown below), you

will have to turn the power off on the Firepower 4100, remove the cables, route the cables through the cable mounting

brackets, reattach the cables, and continue with step 7 below.

Make sure that the cables have enough slack to route them through the cable mounting brackets (as shown in

Note

step 6 below).

If you are installing the FIPS opacity shield after the initial product installation, the cables are already

Important

connected. If the attached cables do not have enough slack to route them through the cable mounting brackets

(as shown below), power down the appliance, remove the cables, route the cables through the cable mounting

brackets, reattach the cables, and continue with step 7 below.

Cisco Firepower 4100 Series Hardware Installation Guide

Connect Cables, Turn on Power, and Verify Connectivity, on page 55

Slide rail locking bracket

Mount and Connect

for the

Table of Contents

Show Quick Links

Chapters

Table of Contents