Installing The Switch Module In The Blade Server - Cisco Catalyst Blade Switch 3020 Installation Manual

Hide thumbs Also See for Catalyst Blade Switch 3020:

Table of Contents

Installing the Switch Module in the Blade Server

Before you install the switch module in the blade server, consider these points:

•

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Warning

Statement 1030

Caution

To prevent electrostatic-discharge (ESD) damage when installing switch modules, follow your normal

board and component handling procedures.

Note

Follow these steps to install the switch module in the blade server:

If you have not already done so, touch the static-protective package that contains the switch module to

Step 1

an unpainted metal part of the blade server for at least 2 seconds.

Remove the switch module from its static-protective package.

Step 2

Remove the interconnect blank from the bay where you plan to install the switch module, if one is

Step 3

present, and install the switch module. (See

Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide

2-6

Review and become familiar with the safety guidelines in the Regulatory Compliance and Safety

Information for the Cisco Catalyst Blade Switch 3020 for HP that accompanies this guide.

Review and become familiar with the safety guidelines in the HP BladeSystem enclosure setup and

installation guide.

Review and become familiar with the temperature, power, and grounding requirements specified in

the HP BladeSystem enclosure setup and installation guide.

When you install a switch module, you do not need to power down the blade server.

Figure

2-2.)

Chapter 2

Switch Installation

OL-8914-02

Table of Contents