Preparing To Download Or Upload A Configuration File By Using Tftp; Downloading The Configuration File By Using Tftp; Uploading The Configuration File By Using Tftp - Cisco Catalyst 3750 Software Configuration Manual
Metro switch
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Hardware installation manual (231 pages) ,
- Message manual (120 pages)
Table of Contents
Advertisement
Working with Configuration Files
Step 4
Copy the configuration file to the appropriate server location. For example, copy the file to the TFTP
directory on the workstation (usually /tftpboot on a UNIX workstation).
Step 5
Make sure the permissions on the file are set to world-read.
Copying Configuration Files By Using TFTP
You can configure the switch by using configuration files you create, download from another switch, or
download from a TFTP server. You can copy (upload) configuration files to a TFTP server for storage.
This section includes this information:
•
•
•
Preparing to Download or Upload a Configuration File By Using TFTP
Before you begin downloading or uploading a configuration file by using TFTP, do these tasks:
•
•
•
•
•
•
Catalyst 3750 Metro Switch Software Configuration Guide
B-10
Appendix B
Preparing to Download or Upload a Configuration File By Using TFTP, page B-10
Downloading the Configuration File By Using TFTP, page B-11
Uploading the Configuration File By Using TFTP, page B-11
Ensure that the workstation acting as the TFTP server is properly configured. On a Sun workstation,
make sure that the /etc/inetd.conf file contains this line:
tftp dgram udp wait root /usr/etc/in.tftpd in.tftpd -p -s /tftpboot
Make sure that the /etc/services file contains this line:
tftp 69/udp
Note
You must restart the inetd daemon after modifying the /etc/inetd.conf and /etc/services files.
To restart the daemon, either stop the inetd process and restart it, or enter a fastboot
command (on the SunOS 4.x) or a reboot command (on Solaris 2.x or SunOS 5.x). For more
information on the TFTP daemon, refer to the documentation for your workstation.
Ensure that the switch has a route to the TFTP server. The switch and the TFTP server must be in
the same subnetwork if you do not have a router to route traffic between subnets. Check connectivity
to the TFTP server by using the ping command.
Ensure that the configuration file to be downloaded is in the correct directory on the TFTP server
(usually /tftpboot on a UNIX workstation).
For download operations, ensure that the permissions on the file are set correctly. The permission
on the file should be world-read.
Before uploading the configuration file, you might need to create an empty file on the TFTP server.
To create an empty file, enter the touch filename command, where filename is the name of the file
you will use when uploading it to the server.
During upload operations, if you are overwriting an existing file (including an empty file, if you had
to create one) on the server, ensure that the permissions on the file are set correctly. Permissions on
the file should be world-write.
Working with the Cisco IOS File System, Configuration Files, and Software Images
78-15870-01
Advertisement
Table of Contents
Troubleshooting
