Enabling Bpdu Guard - Cisco Catalyst 3750 Software Configuration Manual
Metro switch
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Hardware installation manual (231 pages) ,
- Message manual (120 pages)
Table of Contents
Advertisement
Chapter 16
Configuring Optional Spanning-Tree Features
Enabling BPDU Guard
When you globally enable BPDU guard on interfaces that are Port Fast-enabled (the interfaces are in a
Port Fast-operational state), spanning tree shuts down Port Fast-enabled interfaces that receive BPDUs.
In a valid configuration, Port Fast-enabled interfaces do not receive BPDUs. Receiving a BPDU on a
Port Fast-enabled interface signals an invalid configuration, such as the connection of an unauthorized
device, and the BPDU guard feature puts the interface in the error-disabled state. The BPDU guard
feature provides a secure response to invalid configurations because you must manually put the interface
back in service. Use the BPDU guard feature in a service-provider network to prevent an access port
from participating in the spanning tree.
Caution
Configure Port Fast only on interfaces that connect to end stations; otherwise, an accidental topology
loop could cause a data packet loop and disrupt switch and network operation.
You also can use the spanning-tree bpduguard enable interface configuration command to enable
BPDU guard on any interface without also enabling the Port Fast feature. When the interface receives a
BPDU, it is put in the error-disabled state.
You can enable the BPDU guard feature if your switch is running PVST+, rapid PVST+, or MSTP.
Beginning in privileged EXEC mode, follow these steps to globally enable the BPDU guard feature. This
procedure is optional.
Command
Step 1
configure terminal
Step 2
spanning-tree portfast bpduguard default
Step 3
interface interface-id
Step 4
spanning-tree portfast
Step 5
end
Step 6
show running-config
Step 7
copy running-config startup-config
To disable BPDU guard, use the no spanning-tree portfast bpduguard default global configuration
command.
You can override the setting of the no spanning-tree portfast bpduguard default global configuration
command by using the spanning-tree bpduguard enable interface configuration command.
78-15870-01
Purpose
Enter global configuration mode.
Globally enable BPDU guard.
By default, BPDU guard is disabled.
Specify the interface connected to an end station, and enter
interface configuration mode.
Enable the Port Fast feature.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 3750 Metro Switch Software Configuration Guide
Configuring Optional Spanning-Tree Features
16-11
Advertisement
Table of Contents
Troubleshooting
