Chapter 29 Configuring Qos - Cisco Catalyst 2950 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (544 pages)
Table of Contents
Advertisement
Configuring QoS
This chapter describes how to configure quality of service (QoS) by using automatic-QoS (auto-QoS)
commands or by using standard QoS commands. With QoS, you can give preferential treatment to
certain types of traffic at the expense of others. Without QoS, the Catalyst 2950 or Catalyst 2955 switch
offers best-effort service to each packet, regardless of the packet contents or size. It sends the packets
without any assurance of reliability, delay bounds, or throughput.
To use the features described in this chapter, you must have the enhanced software image (EI) installed
on your switch.
If you have the standard software image (SI) installed on your switch, you cannot configure some of the
features.
Table 29-1
Topic
Queueing and scheduling at the
egress ports
Configuring QoS
For complete syntax and usage information for the commands used in this chapter, see the command
Note
reference for this release.
The switch supports some of the modular QoS CLI (MQC) commands. For more information about the
MQC commands, see the "Modular Quality of Service Command Line Interface Overview" at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt8/qcfmdcli.ht
m#89799
QoS can be configured either by using Network Assistant or the command-line interface (CLI). See the
Network Assistant online help for configuration procedures.
78-11380-12
Table 29-1
lists the sections that describe the features that you can configure.
Sections Describing Standard Software Features
Section
"Queueing and Scheduling" section on page 29-8
"Configuring Standard QoS" section on page 29-18
"Default Standard QoS Configuration" section on page 29-18
"Configuring Classification Using Port Trust States" section on
page 29-20
"Configuring the Egress Queues" section on page 29-37
C H A P T E R
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
29
29-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
