Table of Contents
Advertisement
IPV5000, IPV5001, IPV6003, IPV6005, and IPV6006
Front Panel
1 2
1 Power
2 Power LED
3 SIG LED
4 HD LED
5 REC LED
6 USB Port
Note: This illustration may vary from the actual product.
CAUTION:
Your set-top may be equipped with a hard disk drive to store programs that
you record and to allow you to rewind and pause live TV. Any time the set-
top is powered on (power LED is illuminated) or a recording is in progress
(the record LED is illuminated) the hard disk drive is in use.
If you need to move the set-top, complete the following steps to allow the
hard disk drive to shut down properly. First, make sure that no recording is
in progress (record LED is off ). Then, turn off power by pressing the Power
switch. Finally, unplug the unit and wait 10 seconds for the hard disk drive
to spin down (stop). At this point the unit can be moved safely.
You should handle this product with the same level of care that you would
use when handling other electronics containing a hard disk drive, such as
a laptop computer or other hard disk drive-equipped devices.
8
SIG
HD
REC
3
4
5
Turns the set-top on or places it in standby
Indicates that the set-top is powered on. The LED is white
Indicates network link status. The LED is green
Indicates that the set-top is set to a resolution of 720p, 1080i, or 1080p.
The LED is yellow
Indicates that a recording is in progress. The LED is red
USB connector
6
Hide quick links:
Advertisement
Table of Contents
