Table of Contents
Advertisement
Switch Installation
Figure 27: Attaching flexible mount assembly to strut channel
Note
Step 4
Connect to a power source.
• To connect the assembly which uses flexible mount with direct-wired junction box
(CDB-MNT-FLEX-DIR) to a power source, use an armored cable. See
CDB-MNT-FLEX-DIR accepts 100V – 277V AC Input.
• To connect the assembly which uses flexible mount with IEC C14 power junction box
(CDB-MNT-FLEX-C14) to a power source, use country-specific power cord.
CDB-MNT-FLEX-C14 accepts 100V – 240V AC Input.
Step 5
Slide the switch into the flexible mount in a front mounting position as shown in the figure and tighten thumb
screws to secure the switch to flexible mount.
In the following figure, 3/8" hole is used to attach the assembly to the strut channel. You can also
use 1/4" hole to attach the assembly to the strut channel.
Catalyst Digital Building Series Switch Hardware Installation Guide
Flexible Mounting
Electrical Installation
section.
41
- Quick Links:
- Rear Panel
Hide quick links:
Advertisement
Table of Contents
