Configuring Ioa - Cisco MDS 9000 series Configuration Manual
I/o accelerator
Hide thumbs
Also See for MDS 9000 series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Configuring IOA
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Configuring IOA
In this chapter, all configuration steps relate to a reference topology shown in
RTP represent two sites connected through the WAN or MAN ISLs. In this example, sjc-sw2 and rtp-sw2
represent the core switches where IOA is deployed. sjc-sw1 and rtp-sw1 are edge switches that has the
hosts or targets connected to them.
Figure 4-1
The process of configuring IOA involves a number of configuration tasks that should be completed in
order:
On each IOA switch, complete the following configurations:
•
•
•
•
On the master IOA switch, complete the following configurations:
•
•
•
•
•
Cisco MDS 9000 Family I/O Accelerator Configuration Guide
4-2
IOA CLI Reference Topology
Site: SJC
MSM
sjc-sw2
sjc-sw1
Enabling Clustering, page 4-3
Enabling the IOA Service, page 4-3
Classifying the Switches to IOA Sites, page 4-3
Configuring IOA Interfaces, page 4-4
Configuring an IOA Cluster, page 4-5
Adding Nodes to an IOA Cluster, page 4-6
Adding Interfaces to an IOA Cluster, page 4-8
Adding N Ports to an IOA Cluster, page 4-9
Configuring the IOA Flows, page 4-10
Chapter 4
MAN/WAN
ISLs
rtp-sw2
OL-20708-01, Cisco MDS NX-OS Release 5.0(1a)
Configuring IOA Using the CLI
Figure 4-1
where SJC and
Site: RTP
MSM
rtp-sw1
Advertisement
Table of Contents
