Verifying The Ioa Interface; Task Flow For Converting An Existing Ioa Cluster To Use Ipfc Interface; Configuration Example For Converting Ioa Cluster To Use The Ipfc Interface; Verifying The Ioa Cluster Configuration - Cisco MDS 9000 series Configuration Manual
I/o accelerator
Hide thumbs
Also See for MDS 9000 series:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Chapter 2
Getting Started
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Verifying the IOA Interface
The following example verifies the IOA interface that is configured on the switch using show ioa cluster
cluster name interface summary command:
sw-231-14# show ioa cluster cltr1 int summary
-------------------------------------------------------------------------------
Switch
-------------------------------------------------------------------------------
sw-231-14(L)
sw-231-14(L)
sw-231-19
sw-231-19
sw-231-14#
Task Flow for Converting an Existing IOA Cluster to use IPFC interface
To convert an existing IOA cluster to use the IPFC Interface, follow these steps:
•
•
•
•
•
•
•
Configuration Example for Converting IOA Cluster to Use the IPFC interface
This example for converting an IOA cluster to use the IPFC interface has the following steps:
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-20708-01, Cisco MDS NX-OS Release 5.0(1a)
Interface
ioa1/1
ioa1/2
ioa4/1
ioa4/2
Shut down IOA cluster on both the nodes.
Remove the IOA cluster that is configured on remote node.
Remove the remote node from the cluster and convert it as a single node cluster.
Change the node to use IPFC by entering the commands node id id nodename and ip-address IPFC
address.
Bring the single node cluster by no-shut.
Add the remote node and its interface.
Verify using show commands.
Verifying the IOA Cluster Configuration, page 2-14
Verifying the IP Address, page 2-14
Verifying the Flow Status, page 2-14
Shutting Down IOA Cluster on a Local Node, page 2-14
Shutting Down the IOA cluster on the remote node, page 2-15
Removing the IOA Cluster from the Remote Node, page 2-15
Verifying the IOA Cluster in the Remote Node, page 2-15
Removing the Remote Node from the Cluster in the Local Switch, page 2-15
Changing the Local Node Configuration to use IPFC Address, page 2-15
Activating the Single Node Cluster, page 2-15
Adding Remote Node with IPFC Address, page 2-16
Adding IOA Interfaces to the Remote Node, page 2-16
Verifying the Cluster Nodes, page 2-16
Status
Flows
up
0
up
0
up
0
up
0
Cisco MDS 9000 Family I/O Accelerator Configuration Guide
Using IOA Cluster with IPFC Interface
2-13
Advertisement
Table of Contents
