Frame Service Module Features; Introduction; Types Of Frame Service Modules - Cisco MGX 8850 Installation And Configuration Manual
Multiservice switch
Hide thumbs
Also See for MGX 8850:
- Command reference manual (786 pages) ,
- Product manual (62 pages) ,
- Installation and configuration manual (4 pages)
Table of Contents
Advertisement
Frame Service Module Features
This section describes the features available on each of the Frame Service Modules (FRSMs). For
descriptions of how to set up these cards and add connections, see the subsequent section titled
"Configuring Frame Relay Service." This section consists of:
•
Brief descriptions of each model of the FRSM
•
Lists of features shared by all FRSMs
•
Lists of features for individual models of the FRSM
•
Brief descriptions of the services
Introduction
The primary function of the FRSM is to convert between the Frame Relay-formatted data and
ATM/AAL5 cell-formatted data. For an individual connection, you can configure network
interworking (NIW), service interworking (SIW), ATM to Frame Relay UNI (FUNI), or frame
forwarding. An FRSM converts the header format and translates the address for:
•
Frame Relay port number and DLCI
•
ATM-Frame UNI (FUNI) port number and frame address or frame forwarding port
•
ATM virtual connection identifier (VPI/VCI)
Types of Frame Service Modules
The models of the FRSM include eight-port T1 and E1 cards and very high-speed modules. Higher
speed modules support unchannelized E3 and HSSI as well as channelized and unchannelized T3.
Very High Speed Frame Service Modules
The Very High Speed Frame Service Modules (FRSM-VHS) support Frame Relay services on T3,
E3, and HSSI interfaces. Up to 24 FRSM-VHS cards in any combination can operate in the switch.
They should occupy upper slots whenever possible. The FRSM-VHS group on an MGX 8850 node
consists of the:
•
MGX-FRSM-2CT3, which provides channelized Frame Relay service for up to 1000 user
connections over two T3 lines on the BNC-2T3 back card (or line module).
•
MGX-FRSM-2T3E3, which provides unchannelized (clear-channel) Frame Relay service for up
to 1000 user connections over two T3 lines (44.736 Mbps each) or two E3 lines (34.368 Mbps
each) on a BNC-2T3 or BNC-2E3 back card. The MGX-FRSM-2T3E3 can also support subrate
T3 or E3 for tiered DS3 on each physical port.
•
MGX-FRSM-HS2, which provides unchannelized Frame Relay service for up to 1000
user-connections over two HSSI lines on the SCSI2-2HSSI back card. The maximum rate for the
card is 70 Mbps. Each port can operate either as DTE or DCE with incremental rates of NxT1 or
NxE1 up to 52 Mbps.
Eight-Port Channelized and Unchannelized Frame Service Module
The AX-FRSM-8T1 and AX-FRSM-8E1 provide unchannelized Frame Relay service for up to 1000
user-connections on 8 T1 or E1 lines. The AX-FRSM-8T1c and AX-FRSM-8E1c provide
channelized Frame Relay service for up to 1000 connections.
Frame Service Module Features
Card and Service Configuration 6-19
Advertisement
Table of Contents
