Table of Contents
Advertisement
Cisco TelePresence SX20 Quick Set
Contents
Video Selfview
Determine if the main video source (self view) shall be displayed on screen.
This setting is obsoleted by the Video SelfviewDefault Mode setting as from TC6.0.
Requires user role: USER
Value space: <Off/On>
Off: Do not display self view on screen.
On: Display self view on screen.
Example:
Video Selfview: On
Video SelfviewPosition
Select where the small self view PiP (Picture-in-Picture) will appear on screen.
This setting is obsoleted by the Video SelfviewDefault PIPPosition setting as from TC6.0.
Requires user role: ADMIN
Value space: <UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/LowerLeft/
LowerRight>
UpperLeft: The self view PiP will appear in the upper left corner of the screen.
UpperCenter: The self view PiP will appear in the upper center of the screen.
UpperRight: The self view PiP will appear in the upper right corner of the screen.
CenterLeft: The self view PiP will appear on the left side of the screen, in center.
CenterRight: The self view PiP will appear on the right side of the screen, in center.
LowerLeft: The self view PiP will appear in the lower left corner of the screen.
LowerRight: The self view PiP will appear in the lower right corner of the screen.
Example:
Video SelfviewPosition: LowerRight
D14908.02 SX20 Administrator Guide TC6.0, JANUARY 2013.
Introduction
Web interface
System settings
System settings
Video SelfviewDefault Mode
Determine if the main video source (self view) shall be displayed on screen after a call.
The position and size of the self view window is determined by the Video SelfviewDefault
PIPPosition and the Video Selfview FullscreenMode settings respectively.
This setting obsoletes the Video Selfview setting as from TC6.0.
Requires user role: ADMIN
Value space: <Off/Current/On>
Off: Self view is switched off when leaving a call.
Current: Self view is left as is, i.e. if it was on during the call, it remains on after the call; if it
was off during the call, it remains off after the call.
On: Self view is switched on when leaving a call.
Example:
Video SelfviewDefault Mode: Current
Video SelfviewDefault FullscreenMode
Determine if the main video source (self view) shall be shown in full screen or as a small
picture-in-picture (PiP) after a call. The setting only takes effect when self view is switched on
(see the Video SelfviewDefault Mode setting).
Requires user role: ADMIN
Value space: <Off/Current/On>
Off: Self view will be shown as a PiP.
Current: The size of the self view picture will be kept unchanged when leaving a call, i.e. if it
was a PiP during the call, it remains a PiP after the call; if it was fullscreen during the call, it
remains fullscreen after the call.
On: The self view picture will be shown in fullscreen.
Example:
Video SelfviewDefault FullscreenMode: Current
www.cisco.com — Copyright © 2012-2013 Cisco Systems, Inc. All rights reserved.
92
Administrator Guide
Setting passwords
Appendices
- Quick Links:
- Table of Contents
- User Documentation
Hide quick links:
Advertisement
Table of Contents
