Cisco Service Manual Service Manual page 53

Table of Contents

Enlarged version

Cisco TelePresence SX20 Quick Set

Contents

Cameras Camera [1..1] DHCP

Applies to cameras which support DHCP (for example the Cisco TelePresence PrecisionHD

1080p 12X camera). The camera must be connected to a LAN. When set, the command

enables support for SW upgrade of daisy chained cameras. It will enable the camera's DHCP

function and force start of MAC and IP address retrieval. Remember to reset the DHCP when

the camera is no longer connected to a LAN.

Requires user role: ADMIN

Value space: <Off/On>

Off: Disable DHCP in the camera. NOTE: This setting should be applied when the camera is

not connected to a LAN.

On: Enable DHCP in the camera. The camera is automatically re-booted. After re-boot the

DHCP is started and the IP address will be retrieved. Run the commnand "xStatus Camera"

for result.

Example:

Cameras Camera 1 DHCP: Off

D14908.02 SX20 Administrator Guide TC6.0, JANUARY 2013.

Introduction

Web interface

System settings

Administrator Guide

Setting passwords

Appendices

Table of Contents

Show Quick Links

Table of Contents