Installing Ac Power Plug On Air-Cord-R3P-40Ue - Cisco Aironet 1570 Series Installation Manual
Outdoor
Hide thumbs
Also See for Aironet 1570 Series:
- Ordering manual (17 pages) ,
- Hardware installation manual (10 pages) ,
- Mounting (52 pages)
Table of Contents
Advertisement
Chapter 4
Installing Other Components
•
•
The AP1572EAC supports the following AC power cables and connectors available from Cisco:
AC Power Cord,
Connector
AC Power Cord
AIR-CORD-R3P-40NA=
AC Power Cord
AIR-CORD-R3P-40UE=
Field-installable
Connector
AIR-ACC15-AC-PLGS=
Installing AC Power Plug on AIR-CORD-R3P-40UE=
When using a user-supplied AC power plug on the AIR-CORD-R3P-40UE= power cord, ensure that the
plug is certified for outdoor use and that it has a minimum IP67 rating, such as Interpower 84131251 or
Hubbell HBL316P6W (IEC/EN 60309) pin-and-sleeve type connectors. The power cord plug pinouts are
listed in
OL-32138-01
You must protect all AC power plugs and AC receptacles from water and other outdoor elements.
You can use a UL-listed waterproofing enclosure suitable for covering the AC receptacle and AC
power plug that supplies power to the unit as described in Article 406 of the NEC.
When you install the access point in a wet or damp location, the AC branch circuit that powers the
access point should have ground fault protection (GFCI), as required by Article 210 of the National
Electrical Code (NEC).
Dimensions
Diameter:
0.4 to 0.413 in.
(10.2 mm to 10.5 mm)
Length:
40-ft (12.2-m)
Diameter:
0.4 to 0.413 in.
(10.2 mm to 10.5 mm)
Length:
40-ft (12.2-m)
Cable Diameter
Supported:
9 to 14 mm
Figure
4-17.
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
Powering the Access Point
Description
This cord is for installations in the US and
Canada, and comes with pre-installed
connectors at both ends.
The three prong plug is limited to 120 VAC.
Internal wiring is rated at 600 VAC insulation
protection.
This cord for installations in the European
Union. This cord comes with a pre-installed
connector for connecting to the AP's AC port.
You will need to source and install a
country-specific connector to the blunt cut
end of the cable. For information on installing
an AC power plug, see
Installing AC Power
Plug on AIR-CORD-R3P-40UE=, page
Power cord rating is 100 to 480 VAC. Internal
wiring is 16 AWG.
This is a kit of five field terminable
connectors. For these connectors you will
need to source an appropriate 3-wire AC
cable.
This connector supports a cable of 330 VAC,
13 Amps rating. The wiring size supported is
12 to 16 AWG.
4-27.
4-27
Advertisement
Table of Contents
