Checking The Canister (For California Only); Checking The Coolant Level; Checking The Cooling System - Yamaha WR250R Service Manual
Hide thumbs
Also See for WR250R:
- Owner's manual (100 pages) ,
- Owner's manual (112 pages) ,
- Owner's manual (98 pages)
Table of Contents
Advertisement
2
d. Insert the tailpipe into the muffler and align
the bolt holes.
e. Insert the bolt and tighten it.
Spark arrester bolt
12 Nm (1.2 m•kg, 8.7 ft•lb)
(Apply the molybde-
num-disulfide grease)
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
EAS21090
CHECKING THE CANISTER (FOR
CALIFORNIA ONLY)
1. Remove:
Canister cover
G
Refer to "CANISTER (FOR CALIFORNIA)"
on page 7-13.
2. Check:
Canister
G
Hose
G
Cracks/damage → Replace.
3. Install:
Canister cover
G
Canister cover bolt
10 Nm (1.0 m•kg, 7.2 ft•lb)
EAS21110
CHECKING THE COOLANT LEVEL
1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
G
1
a
Make sure the vehicle is upright.
G
2. Remove:
Seat
G
Air scoop
G
Refer to "GENERAL CHASSIS" on page 4-1.
3. Check:
Coolant level
G
The coolant level should be between the
maximum level mark "a" and minimum level
mark "b".
Below the minimum level mark → Add the
recommended coolant to the proper level.
ECA13470
CAUTION:
Adding water instead of coolant lowers the
G
antifreeze content of the coolant. If water is
used instead of coolant check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.
Use only distilled water. However, if dis-
G
tilled water is not available, soft water may
be used.
4. Start the engine, warm it up for several min-
utes, and then turn it off.
5. Check:
Coolant level
G
NOTE:
Before checking the coolant level, wait a few
minutes until it settles.
6. Install:
Air scoop (left)
G
Seat
G
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21120
CHECKING THE COOLING SYSTEM
1. Remove:
Seat
G
Air scoop (left/right)
G
Refer to "GENERAL CHASSIS" on page 4-1.
Fuel tank
G
Refer to "FUEL TANK" on page 7-1.
2. Check:
Radiator "1"
G
3-17
ENGINE
a
b
Advertisement
Chapters
Table of Contents
Troubleshooting
