Resetting The Device To Default Settings; Resetting To Default Settings Using The Cli; Resetting To Default Settings Using The Gui - Cisco 2100 Series Configuration Manual

Wireless lan controller

Hide thumbs Also See for 2100 Series:

Table of Contents

Configuring Controller SettingsWireless Device Access

Resetting the Device to Default Settings

If you need to start over during the initial setup process, you can reset the controller to factory default

After resetting the configuration to defaults, you need a serial connection to the controller to use the

configuration wizard.

Follow these steps to reset the configuration to factory default settings using the CLI.

Enter reset system. At the prompt that asks whether you need to save changes to the configuration, enter

Y or N. The unit reboots.

When you are prompted for a username, enter recover-config to restore the factory default

configuration. The controller reboots and displays this message:

Welcome to the Cisco WLAN Solution Wizard Configuration Tool

Use the configuration wizard to enter configuration settings.

Follow these steps to return to default settings using the GUI.

Open your Internet browser. The GUI is fully compatible with Microsoft Internet Explorer version 6.0

or later on s platforms.

Enter the controller IP address in the browser address line and press Enter. An Enter Network Password

Enter your username in the User Name field. The default username is admin.

Enter the wireless device password in the Password field and press Enter. The default password is

Browse to the Commands > Reset to Factory Defaults page.

Click Reset. At the prompt, confirm the reset.

Reboot the unit and do not save changes.

Use the configuration wizard to enter configuration settings.

Using the Configuration Wizard

Cisco Wireless LAN Controller Configuration Guide

Show Quick Links

Table of Contents