Table of Contents
Advertisement
Available languages
Available languages
About the controls on the portable room heater.
Features and
appearance
may vary.
Controls
MODE Pad
Press to set to LO heat, HI heat, fan mode or
to return to the standby mode.
Display
Shows the room temperature. Shows the set
temperature while setting the temperature in
LO or HI heat modes. Shows whether set in
LO heat, HI heat or fan mode.
NOTE: The display will change to show the room
temperature after settings have been made. To
recall the set temperature, press the Increase or
Decrease pads.
Increase Pad
Use to increase the set temperature when
in the heat mode.
Decrease Pad
Use to decrease the set temperature when
in the heat mode.
Heat Mode
When in the HI or LO heat mode, use the
Increase/Decrease pads to set the desired
temperature between 40°F and 90°F in 1°F
increments.
Fan Mode
Use the fan mode to provide air circulation
without heating.
Remote Control
I
To ensure proper operation, aim the remote
control at the front of the heater.
I
The remote control signal has a range of
up to approximately 10 feet.
LO
HI
Fan
heat on
heat on
only on
Portable Heater Control
(on some models)
Remote Control
(on some models)
On/Off Pad
Press to turn the heater on. It will turn on in
the standby mode. The display will show the
room temperature.
Press again to turn the heater off.
NOTE: After turning the heater off, the fan
will continue to run for up to one minute
to cool internal parts.
Oscillate Pad
(on some models)
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn on
until the desired air direction is obtained,
then turn it off.
A thermostat is used to maintain the room
temperature. The heater will cycle on and off to
keep the room at the set level of comfort. Set the
thermostat at a higher temperature and the indoor
air will become warmer. Set the thermostat at a
lower temperature and the indoor air will become
less warm.
Since the fan setting does not provide heating, a
temperature setting will not be displayed.
I
Make sure nothing is between the heater and
the remote control that could block the signal.
I
Make sure batteries are fresh and installed
correctly—see the Care and Cleaning section.
ge.com
3
Advertisement
Chapters
Table of Contents
