Technical Information • DMI Viewer Appendix LIMITED USE LICENSE AGREEMENT ... Names and Functions of Parts ... Specifications ... LIMITED WARRANTY ... Personal Computer CF-28 Series • LED Indicators • Port Replicator • Printer • External Display • USB Device •...
Page 2
* For the Model No., insert the 12 digit number (for example, CF-28PTJAZQM) located on the bottom of the computer. Introduction Thank you for purchasing the Panasonic computer. Read the operating instructions thoroughly for proper operation of your new computer. Illustrations and Terminology in this Manual NOTE: NOTE provides a useful fact or helpful information.
Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the Panasonic Service Center or an experienced ra- dio/TV technician for help. Warning To assure continued compliance, use only shielded interface cables when connecting to a computer or peripheral.
Page 4
Read Me First For Canada Industry Canada (IC) Notice for modem This equipment contains an Industry Canada approved modem unit. The Industry Canada label is affixed on the modem unit. EQUIPMENT ATTACHMENT LIMITATIONS “NOTICE: The Industry Canada label identifies certified equipment.
Page 5
Lithium Battery Lithium Battery! This computer contains a lithium battery to enable the date, time, and other data to be stored. The battery should only be exchanged by authorized service personnel. Warning! A risk of explosion from incorrect installation or mis- application may possibly occur.
Page 6
Read Me First Precautions (Battery Pack) Care should be exercised with regard to the following in or- der to avoid the possibility of overheating, fire or damage. Avoid Heat Do not throw the battery pack into a fire or ex- pose it to excessive heat.
Page 7
Saving Data on the Hard Disk Do not expose your computer to shock. Use care when handling your computer, shock may damage your hard disk or make your software applications and data unusable. Do not power off your computer while software applications are running or hard disk drive indicator ( ) is on. Properly shut Windows* down to avoid problems.
Page 8
If the Protective Film becomes dirty or damaged, it may be time to replace your Protective Film. The Protective Film is a disposable item. To find out the model number of your Protec- tive Film, contact Panasonic Technical Support. (For more information, refer to the “Operating Instructions” that come with the Protective Film.)
Confirm the inclusion of all parts Make sure the parts shown in the figure have been supplied. If any of these items are missing or is not working properly, contact Panasonic Technical Support. AC Adaptor ... 1 AC Cord ... 1 Model No : CF-AA1653 Modem Telephone Cable ...
First-time Operation Power Indicator Power Switch Connect your computer to a power outlet CAUTION Be sure the AC adaptor is connected until completing Step 8 on page 11. When closing the cover, first insert the top of the cover. Handling the AC adaptor Do not twist or pull the AC power cord forcefully.
Page 11
Dual OS Select the Operating System Windows 2000 and Windows XP are preinstalled on the computer. After one of them is selected with the following procedure, only that operating system can be used. At the screen for the agreement of the selection of the operating system, press Y . With the number keys, select either Windows 2000 or Windows XP.
First-time Operation Windows XP Windows XP CAUTION Do not press any key or move the touch pad until [Windows XP Professional Setup] is displayed. At the [Welcome to the Windows XP Setup Wizard], select [Next]. After reading the agreement, select [I accept this agreement] or [I don't accept this agreement], then select [Next].
Page 13
When creating backup disks and the message [Insufficient files to copy] is dis- played, select [OK] and then contact Panasonic Technical Support. While the MP indicator ( ) is on, do not remove the floppy disk, power down your computer or enter either the standby or hibernation mode ( Hibernation Functions”).
When the CPU temperature rises, the computer may not power on to prevent the CPU from overheating. Should this happen, allow the computer to cool down then switch the power on again. If the computer still does not power on, contact Panasonic Technical Support. If security indicator ( ) is displayed, you must first enter your password ( Upon entering your password* and pressing Enter .
Page 15
Log on to Windows Windows 2000 Wait for 10 seconds after confirming that the hard disk drive access has been completed, input the user name and password, then select [OK]. Until the correct user name and password are entered, the computer will not operate. Windows XP Wait for 10 seconds after confirming that the hard disk drive access has been completed, select the user and input the password, then select...
Page 16
Starting Up/Shutting Down Shutting Down (power off your computer) This procedure is shutting down without using the standby or hibernation function. “Standby/Hibernation Functions”) Save important data and close each application Display the shut down screen Windows 2000 Select [Start] - [Shut Down]. Windows XP Select [Start] - [Turn Off Computer].
Touch Pad Work Surface Use the touch pad to move the cursor on the display and perform normal computer operations. For instructions on how to operate, refer to The touch pad has been designed to work only when a finger is used. Therefore, do not use other implement on the touch pad.
Select [Reference Manual] in [Start] - [Programs] - [Panasonic] - [On-Line Manuals] Windows XP Select [Reference Manual] in [Start] - [All Programs] - [Panasonic] - [On-Line Manuals] When the Reference Manual is started up for the first time, the License Agreement of the Acrobat Reader will be displayed.
If your system displays one of except the messages marked below with an asterisk (*), write down the message and contact Panasonic Technical Support. If your system fails after you make changes in the Setup menus, reset the computer, enter Setup and install Setup defaults or correct the error.
Page 20
List of Error Codes 02F5: DMA Test Failed ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers. 02F6: Software NMI Failed ServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt). 02F7: Fail - Safe Timer NMI Failed ServerBIOS2 test error: Fail-Safe Timer takes too long.
When a problem occurs, refer to this page. The "Reference Manual" also contains detailed information. If a problem appears to be related to a software application, read the software related manual. If you still cannot troubleshoot the problem, contact Panasonic Technical Support.
Page 22
Dealing with Problems (Summary) Display No display after powering The power has not been turned off, but after a cer- tain period of time, there is no display The cursor cannot be con- trolled An afterimage appears (e.g., green, red, and blue dots remain on the display) or there are dots not display- ing the correct colors...
The battery pack or recharging function may be defective. Quickly remove the battery pack and disconnect the AC adaptor, then connect them again. If the problem persists, contact Panasonic Technical Support. The orange indicator blinks Unable to charge because of an improper temperature range. (...
Reinstalling Software Before Reinstallation Preparing You will need the followings: • Product Recovery CD-ROM • If it was necessary to create BACKUP DISKS ( FD) and the floppy disk drive. • The optional CD drive (Confirm the latest information on optional products in catalogs, etc.) Mount the CD drive in the multimedia pocket.
Page 25
10 At the confirmation message , press Y . The operation of reinstallation for the hard disk starts au- tomatically. When a message appears instructing you to insert the next CD, insert the recovery CD showing the next number in the sequence, and then select [OK].
LIMITED USE LICENSE AGREEMENT THE SOFTWARE PROGRAM(S) ("PROGRAMS") FURNISHED WITH THIS PANASONIC ARE LICENSED ONLY TO THE END-USER ("YOU"), AND MAY BE USED BY YOU ONLY IN ACCORDANCE WITH THE LICENSE TERMS DESCRIBED BELOW. YOUR USE OF THE PROGRAMS SHALL BE CONCLUSIVELY DEEMED TO CONSTITUTE YOUR ACCEPTANCE OF THE TERMS OF THIS LICENSE.
Page 27
Contrat de licence d’usage limité Le(s) logiciel(s) (les “Logiciels”) fournis avec ce produit Panasonic licence à l’utilisateur ultime (“vous”), et ils ne peuvent être utilisés que conformément aux clauses contractuelles ci- dessous. En utilisant les logiciels, vous vous engagez de manière définitive à respecter les termes, clauses et condi- tions des présentes.
Names and Functions of Parts The illustrations shown may differ from the actual physical appearances. LED Indicators “LED Indicators”) Battery pack status Power status Touch Pad page 17) Power Switch Before using the computer for the first time, carefully read the [Limited Use License Agreement].
Page 29
Microphone Jack Use only a monaural condenser microphone. Using an input source other than a monaural condenser mi- crophone may not allow audio to be input or may damage the equipment. The settings for [Internal MIC] of the [Main] menu in the Setup Utility apply to both the Internal Microphone and the Microphone Jack.
Specifications Main Specifications Model No. Memory (Expandable to) Video Memory Type Displayed Colors* External Display Hard Disk Drive Keyboard Floppy Disk Drive Slots PC Card Slots Allowable current (total for two slots) RAM Module Slot* Interface Parallel Port External Display Port Serial Port Microphone Jack* Headphone Jack...
Main Specifications Model No. AC Adaptor* Input Output Power Consumption* Environment In use Temperature Humidity Not in use Temperature Humidity Physical Dimensions (W x H x D) Weight (including the carrying handle) The AC adaptor is compatible with power sources up to 240 V AC adaptor. The computer is supplied with a 125 V AC compatible AC cord. Approx.
God. In addition, Panasonic shall have no obligation for any defects in the disk(s) or other media if you have modified, or attempted to modify any Program.
Page 33
No Coverage – This limited warranty does not apply if the disk(s) or other media has been used in other than a Panasonic product, or in environmen- tal conditions other than those specified by PCI or the manufacturer, or if subjected to misuse, neglect, mishandling, modification or attempted modification of the program, or if damaged by accident or act of God.