L200
Start Here
Read these instructions before using your printer.
This product requires careful handling of ink. Ink may splatter when the ink tanks are
filled or refilled with ink. If ink gets on your clothes or belongings, it may not come off.
Epson recommends that you wear plastic gloves when filling the ink tanks.
Do not open ink bottles until you are ready to fill the ink tanks. Ink bottles are
vacuum packed to maintain reliability.
1
Remove all protective materials
2
Fill ink tanks
When you fill the ink tanks, it is recommended that you place a sheet of
paper under the ink tank unit. If ink spills, wipe it off immediately to avoid
permanent stains.
Keep ink bottles out of the reach of children and do not drink the ink.
1
2
Extra black ink
For initial setup
Do not pull ink
tubes.
3
4
5
6
7
Repeat steps 3 to 6 for each bottle and
corresponding ink tank.
Seal each bottle with stopper. Do not dispose of ink
bottles yet. You will need to enter the codes printed on
each bottle when you install the printer software.
8
9
Be sure to set the transportation lock to the
when using the printer, otherwise ink is not delivered and print quality
problems may occur. Set the transortation lock to the
position only when transporting, otherwise ink may leak.
Remove ink tank cap.
Remove only one tank cap
at a time.
Replace bottle cap tightly, or
ink may leak.
Match the ink color with the
correct tank and then fill with ink
up to the upper line on the tank.
Fit ink tank cap securely.
printing position
transport