Table of Contents
Advertisement
INTEGRAL RSA
Application controllers
Important:
For communication on the RS bus,
the controller must be assigned the
appropriate address, by use of the
rotary switch on the cover plate.
(Factory-setting: Address 1).
Operation and service
The controller can be operated by various means:
– Remotely, from a room operating unit
– Via the RS bus, with an operator terminal or PC
– NBRN-.. operator terminal or service PC for service and commissioning
– NRK16-B/A for simple local operation (see page 8)
– NRK16-WEB/A for operation with an Internet browser
Remote operation
Connection terminals K1, K2, K4 and K6 are provided for remote operation
from a type KR.. room operating unit. The PB.. operating units should be
connected to universal inputs A..J.
Suitable room operating units
KRT-1B Room temperature measurement
Room temperature setpoint adjustment
Mode selection (AUT, ON or OFF)
Heating time extension (by 1, 2 or 4 hours)
KRT-1L Room temperature measurement
Room temperature setpoint adjustment
Mode selection (AUT, ON or OFF)
Holiday mode extension (by 1, 2 or 3 days)
KRU-1 Room temperature measurement
Mode selection (AUT, ON or OFF)
Timer module with independent time function
PBA
Room temperature measurement
Room temperature setpoint adjustment
P B C
Room temperature measurement
Room temperature setpoint adjustment
Digital display of room temperature
See the relevant documentation for maximum cable lengths
Operation via RS bus
Since the controller is compatible with the RS bus, it can be operated
remotely from any of the following devices:
– NBE remote operator terminal (see K21-05.18)
– NBRN-.. operator terminal (see K21-05.10 and 12)
– From a PC running the INTEGRAL DIALOG service software, connected
via the NITEL.. communications module (see K21-07.30) or NARC
RS485-RS232 adapter
– Internet browser, via the NIWEB communications module
Where the INTEGRAL RS system is integrated into a higher-level
system, the controllers can also be operated as follows:
– In an INTEGRAL MS1000, MS2000 or TS1500 building
management system
– In the DESIGO INSIGHT building management system, with advanced
graphics-based operation
Service and commissioning
For service and commissioning purposes an NBRN-.. terminal or a PC can
be connected directly to the service socket on the controller. The same
socket is used to download an application-specific SAPIM program from a
suitable PC (not required for pre-programmed modules).
User manuals
The following user manuals are available for the operator software
described above:
– K23
NBRN.. operator terminals
– K9
INTEGRAL DIALOG
– CA12U3290 NIWEB User manual
– CA1B9110
DESIGO INSIGHT
K21-04.10
7/8
en - 06.2001
Documentation
CA2N1612
CA2N1613
CA2N1614
CA2N1651
CA2N1655
- Quick Links:
- Opening the Controller
Hide quick links:
Advertisement
Table of Contents
