Table of Contents
Advertisement
Configuring the BPX Switch LAN and IP Relay
During the configuration of BPX switch interfaces, you must make sure that the following parameters
are consistently set with your local area network (Ethernet LAN):
•
The BPX switch IP address
•
SNMP parameters
Network IP address
•
To set the parameters, use the BPX switch commands as described in Table 20-1. On BPX and IGX
switches, use these commands to configure the nodes for operation with Cisco WAN Manager.
Table 20-1 BPX Switch Commands
Name
cnflan
cnfsnmp
cnfnwip
cnfstatmast
For more information on how to use these commands, refer to the Cisco WAN Switching Command
Reference or the Cisco WAN Switching SuperUser Command Reference. SuperUser commands may be
used only by authorized personnel with great care.
Figure 20-2 Cisco WAN Manager Physical LAN and IP Relay Network
Cisco
WAN Manager
NMS
Cisco BPX 8600 Series Installation and Configuration
20-4
Description
Configures the BPX switch BCC LAN port IP address and subnet mask. This
SuperUser command is necessary only for nodes or shelves in which the LAN port
is actually connected to a physical Ethernet LAN as shown in Figure 20-2.
Configures the following SNMP Get and Set community strings for the BPX
switch:
Get Community String = public
•
Set Community String = private
•
Trap Community String = public
•
Configures the virtual IP network (IP relay) among BPX switches. This is a
Superuser command.
Defines the IP address for routing messages to and from the Statistics Manager in
CiscoView.
Ethernet LAN
204.179.31.XX
BPX
switch
MGX
8220
IP relay
network
IGX
204.179.55.XX
switch
Chapter 20
IGX
switch
IGX
switch
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Configuring Network Management
Advertisement
Table of Contents
Troubleshooting
