Brother MFC-8440 Software User's Manual page 20
Hide thumbs
Also See for MFC-8440:
- User manual (426 pages) ,
- Service manual (367 pages) ,
- Software user's manual (183 pages)
Table of Contents
Advertisement
5
After the printed envelope comes out of the machine, the
machine will wait until you put in the next envelope. Repeat Step
4 for each envelope you want to print.
6
Send the print data to the machine.
7
After you finish the print job, close the back output tray.
For MFC-8840D, MFC-8840DN and DCP-8045D:
2
Open the back output tray, and then unfold the face-up output
tray support if necessary.
3
Open the MP tray and lower it gently.
4
Pull out the MP tray support flap.
If envelopes are creased after they have been printed:
At the back of the machine, open the back output tray and push
down the blue tabs at the left and right hand sides (as shown in
the figure on the next page). When you have finished printing
your envelopes, close the back output tray to reset the two blue
tabs back to their original position.
1 - 13 USING THE MACHINE AS A PRINTER
Advertisement
Table of Contents
