EMU26141
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pressing the switch "
board motor up, then tilts it up. Pressing the
switch "
" (down) tilts the outboard motor
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 37 and 40.
EMU26151
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on the
side of the bottom engine cowling. Pressing
the switch "
" (up) trims the outboard motor
up, then tilts it up. Pressing the switch "
" (up) trims the out-
Basic components
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could dis-
tract the operator, increasing the risk of
collision with another boat or an obstacle.
UP
DN
1. Power trim and tilt switch
NOTE:
For instructions on using the power trim and
tilt switch, see page 40.
EMU30900
Variable trolling RPM switches
The trolling speed can be adjusted when the
outboard motor is trolling. Press the "
switch to increase the trolling speed and
press the "
" switch to decrease the trolling
speed.
NOTE:
The trolling speed changes approximately
G
50 r/min each time a switch is pressed.
"
1
ZMU04231
"
13