Overheat Warning Indicator (Digital Type); Speedometer (Digital Type); Trim Meter (Digital Type) - Yamaha F100D Owner's Manual
Hide thumbs
Also See for F100D:
- Owner's manual (98 pages) ,
- Service manual (249 pages) ,
- Owner's manual (100 pages)
Table of Contents
Advertisement
EMU26581
Overheat warning indicator (digital
type)
If the engine temperature rises too high, the
warning indicator will start to blink. For further
information on reading the indicator, see page
26.
ECM00050
CAUTION:
Do not continue to run the engine if the
overheat warning indicator is on. Serious
engine damage will occur.
1
1. Overheat warning indicator
EMU26600
Speedometer (digital type)
This gauge shows the boat speed.
1. Speedometer
2. Fuel gauge
3. Trip meter/clock/voltmeter
4. Warning indicator(s)
NOTE:
After the main switch is first turned on, all seg-
ments of the display come on as a test. After
a few seconds, the gauge will change to nor-
mal operation. Watch the gauge when turning
on the main switch to make sure all segments
come on.
NOTE:
The speedometer displays km/h, mph, or
knots, according to operator preference. Se-
lect the desired unit of measurement by set-
ting the selector switch on the back of the
gauge. See the illustration for settings.
ZMU01737
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26620
Trim meter (digital type)
This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best for
G
your boat under different conditions. Adjust
the trim angle to the desired using the pow-
er trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
Basic components
17
- Quick Links:
- Battery Requirement
- Specifications
Hide quick links:
Advertisement
Table of Contents
