Maintenance; Transporting And Storing Outboard Motor; Storing Outboard Motor - Yamaha F75 Owner's Manual
Hide thumbs
Also See for F75:
- Owner's manual (234 pages) ,
- Installation manual (224 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
EMU43860
Transporting and storing out-
board motor
EWM02620
WARNING
USE CARE when transporting fuel tank,
●
whether in a boat or car.
DO NOT fill fuel container to maximum
●
capacity. Gasoline will expand consider-
ably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
Leaking fuel is a fire hazard. When trans-
●
porting and storing the outboard motor,
disconnect the fuel line from the out-
board motor to prevent fuel from leak-
ing.
Never get under the outboard motor
●
while it is tilted. Severe injury could oc-
cur if the outboard motor accidentally
falls.
Do not use the tilt support lever or knob
●
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the outboard motor
cannot be trailered in the normal run-
ning position, use an additional support
device to secure it in the tilt position.
When storing or transporting the outboard
motor, make sure to follow the procedure list-
ed below.
Disconnect the fuel line from the outboard
●
motor.
Tighten the fuel tank cap and its air vent
●
screw.
Store the fuel tank in a well-ventilated
●
place.
Store the fuel tank in a place that is stable
●
and not exposed to shocks.
When the outboard motor is tilted prolonged
time for mooring or trailering the boat, make
sure to follow the procedure listed below.
Disconnect the fuel line from the outboard
●
motor.
Tighten the fuel tank cap and its air vent
●
screw.
The outboard motor should be transported
and stored in the normal running position. If
there is insufficient road clearance in this po-
sition, then trailer the outboard motor in the tilt
position using a motor support device such as
a transom saver bar. Consult your Yamaha
dealer for further details.
EMU30061
Storing outboard motor
When storing your Yamaha outboard motor
for prolonged periods of time (2 months or
longer), several important procedures must
be performed to prevent excessive damage. It
is advisable to have your outboard motor ser-
viced by an authorized Yamaha dealer prior to
storage. However, you, the owner, with a min-
imum of tools, can perform the following pro-
cedures.
ECM01360
NOTICE
To prevent problems which can be
●
caused by oil entering the cylinder from
the sump, keep the outboard motor in
the attitude shown when transporting
and storing it. Do not store or transport
the outboard motor on its side (not up-
right).
Do not place the outboard motor on its
●
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through the
exhaust port and cause engine trouble.
Store the outboard motor in a dry, well-
●
ventilated place, not in direct sunlight.
Maintenance
67
- Quick Links:
- Engine Oil Requirements
Hide quick links:
Advertisement
Table of Contents
